Should be common to the parking/tailight fuse
Sounds like Stop light switch needs to be replaced Sounds like Stop light switch needs to be replaced
turn signal switch needs replaced!
When break lights do not turn off when the brake pedal is fully retracted suggests two possible causes: * The brake light switch is out of adjustment and needs to be adjusted. * The brake light switch is defective and needs to be replaced.
the brake light switch on the brake pedal is bad and needs to be replaced. A $10.50 part at parts store.
The brake lights won't turn off because the brake light switch on the pedestal of the brake pedal needs to be replaced.
If you have the same bulb for brake and signal, brake light power needs to be interrupted by the signal lights, The brake circuit has to go through the signal light switch so the problem could be there.
Switch on brake pedal needs tightened replaced, or switch for lights needs tightened or replaced.
Bulbs. All the bulbs are fed from the same fuse.
on the dashboard of my 2005 325i BMW there is a warning light that is not shown in my manual. the entire car is light up, and at the back left rear there is a red lamp light. To above statement: A light is out and needs to be replaced.
Most probably the light switch assembly on the steering column needs replaced.
When the signal lights are not working on a car, there are a couple of things that could be going on. One could be that the bulb needs to be replaced. The other possibility is that the signal relay needs to be replaced.
If these two lights come on together then the extra traction sensor is broken and needs to be replaced when the sensor is fixed the check engine light will go off and the ets light will work properly again.