There is no specific pinion nut torque. The pinion nut has to be tightened until the proper pinion preload is established. Pinion preload is what matters
There is no specific pinion nut torque that needs to be reached.. You just need to tighten the nut until the correct pinion preload is reached.
Torque specs on a 2007 ram pinion
Preload is the amount the pinion bearings are squeezed together by the pinion nut.
What is the torque specs on a 2001 ford truck rear end pinion nut..
After removing the pinion nut, a 2 jaw puller should do the trick.
remove rear drive shaft from vehicle.remove large nut ( pinion nut) at front of diff, which is generally hidden when driveshaft is in place.with a bearing puller remove pinion bearing, replace with new one. install new pinion seal. reinstall pinion cover and pinion nut. tighten to specified torgue.reinstall driveshaft check diff oil for proper amount
you need a rack and pinion nut breaker to which you fix a pinion at the free end ie where nut is placed to be cracked. This is because you need to convert reciprocating motion of the rack and pinion mechanism built in the nut cracker into circular motion. Attach the nut cracker to the collect chuck shaft through the bore of the additional pinion you installed at the free end of the cracker. When you punch the nut cracker vide its handle once it moves the pinion one tooth on the rack. Thus you can rotate ( ie give angular motion to ) the fixed workpiece from one tooth or as many teeth as you like., depending on the pitch of the threads on the rack and pinion. mazHur
The General Motors 3.42 rear end pinion?ænut torque specification is 240 pounds. The pinion nut should be torqued in 80 pound intervals.
i think 210
210ft. lbs.
I don't believe there is a specific torque specification! Once you install the crush sleeve and tighten the nut to the desired preload on your pinion bearings, your torque will be what it will be.