0
Also known as Rear Beam bushings on some cars
This Bushing helps adsorb the bumps in the road and provide a smooth ride. When it wears out it can feel very similar to when the rear shocks are blown.
A how to replace this part on a VW Golf 93 - 99.5 is here:
http://forums.vwvortex.com/zerothread?id=3242686
Wiki User
∙ 16y ago
Add your answer:
Earn +20 pts
Can a peugoet 306 rear axel fit a citroen ZX rear axel?
yes but only if a domestocated rapes it
What is a rear axel?
Also known as Rear Beam bushings on some cars This Bushing helps adsorb the bumps in the road and provide a smooth ride. When it wears out it can feel very similar to when the rear shocks are blown. A how to replace this part on a VW Golf 93 - 99.5 is here: http://forums.vwvortex.com/zerothread?id=3242686
Where does a pilot bushing go on a clutch rod for a 1975 corvette 350?
The pilot bushing is installed into the rear of the crankshaft. The pilot bushing supports the input shaft of the transmission.
Why does a 4l60e rear seal keep popping out?
It is either the WRONG seal or the tailshaft bushing is worn out. Replace bushing and seal.
Does a vw jetta have rear trailing arm bushing?
Yes
How replace rear differential bushing-srx Cadillac?
very carefully
What is the axel ratio on a 1992 ranger with an rear axel code of L73?
3:73 with a limited slip
How does a rear axel work?
a rear axel is the most common part of any wheeled device that has a front axel. these two axels are sperated into two groups; the front (front axel) and the rear (rear axel) being the most common of the two. now that we've broken these groups down understanding the fundimentles of the complexity that is konw as the rear axel will be as easy as pie. most people mistake the axle as just a long shaft with two wheels, but in fact there is a lot more to it than that. The rear axel of a rear wheel drive automobile has a distinguishing chunck in the center. this is called the differential. this opposing mass of iron houses gears that convert tourq into volocity, this in turn, has the power tomake one go faster. and this has concluded all that anyone would need to to know about a rear axel. if you are still aving trouble finding the rear axel something you should look for is the back end of the automobile. in this area you'll see a set of wheels. these wheels are located on both sides of the automobile. if you shove your head under the automobile in this aera you'll see the rear axel. remember to always check your blinker fluid. what is dlinker fuid
What is FA and RA capacity?
I believe it is Front Axel (FA) and Rear Axel (RA) load capacity in lbs.
Is there a difference between the KZ650 rear caliper and the KZ1000?
a 1000 uses a 20mm axel, a 650 uses a 17mm axel
Why does a 4L60E rear seal keep going out?
The front driveshaft yoke slides up into the seal and also into a bushing. If the bushing is worn, it will eat up a new seal quickly and start leaking. Check for side to side play or lost motion between the yoke and bushing. If there is any, replace the bushing and rear seal. Also look for a good clean smooth surface on the yoke slider. Also check for a bad U-joint that will cause driveshaft vibration and lead to bushing wear.
How do you replace the rear trans seal where the driveshaft comes out on a 78 Chevy truck?
u have to pull the driveshaft knock out the seal and install a new one, but if it is leaking the bushing needs to be replaced and u would need a bushing driver to install it. u can purchace a seal and bushing kit but the bushing is harder to replace
