When two electronic equipments are put one after the other. The input of the last device is the load resistance. Scroll down to related links and look at the first figure of "Calculator Voltage Bridging - Interconnection of Two Audio Units".
it is passive load
A:is equal to the source
Ohm's Law: Voltage is equal to current times resistance 0.002 amperes times 10,000 ohms equals 20 volts.
Ripple voltage, in the presence of a filter capacitor, is inversely proportional to load resistance. If the load were zero (resistance infinite), then there would be no ripple voltage. As the load increases (resistance decreases), the ripple voltage increases. The ripple waveform will appear to be sawtooth, with the rising edge following the input AC from the diode's conductioin cycle, and with the falling edge either being linear or logarithmic, depending on load. If the load is resistive, without a regulator, the falling edge will be logarithmic. If the load is constant current, such as with a regulator, the falling edge will be linear.
The load on a door bell circuit is the coil of the ringer. It is dependant upon the coil resistance and the voltage the system uses. The equation to use is A = E/R, Amps = Volts/Resistance.
source
Load current is related to load resistance by an inverse relationship. The load current increases linearly as load resistance decreases. Remember, the less resistance, the more current.
No. Load resistance is the value of the element actually doing the work of the circuit it is connected to. A speaker connected to an amplifier is the load.
when source resistance and load resistance are equal maximum power is transfered
The resistance arm is the side of the lever (from the fulcrum to the load) that carries the load.
Depending on who is asking about, it could be. But strictly speaking, no. When referring to "load", this could be resistance and reactance (Load at a certain power factor).
Because by increasing the load resistance, the total circuit resistance is reduced. This means with less resistance, there is more current drawn from the source. Doubling the size of a load resistor increases the load current.
specification of inductive load,capactive load,resistive load in laboratory
The total resistance of a circuit is the sum of the supply's internal resistance and its load resistance, because they are in series with each other. This is true regardless of the magnitude of, or the variation in, the current.
explain why all the load must be removed when to conduct the insulation and resistance testing
The dc load resistance is Rc but the AC Load resistance is (RcRl). If a load line is drawn the slope of which is -1(Rc Rl) . Then it is called an AC load line and it is to be used when the transistor is operating as an amplifier.
50
It is load resistance RL. It can be any device that can act as a load at the output end. Example : A resistor