4 qts for the radiator alone.
If the entire system is drained (block, heater, radiator) it would take 12 to 14 quarts.
starter solenoid is on the inside of the fender twards the cab from the battery follow the positive battery cable at the end will be the solenoid
Yes. The 352, 360, 390, 406, 410, 427, and 428 are all FE's and are based on the same engine block. I have a 76 F250 4x4 highboy with a 390 and my brother has one with a 428. The engine mounts are the same and the 428(also 427) will bolt directly to your transmission (NP435 or C6). If you have or are building a 428, remember this engine is externally balanced (the 390 is internally balanced) so the flywheel (if manual trans flexplate if auto) needs to be balanced with the rotating assembly.
I Would say the choke on your one barrel carburetor is sticking Start the engine. Let the engine reach operating temperature.Remove your Air cleaner to your Carburetor while the engine is running.Look down the throat of the carburetor and you will see a round flap A.K.A the butterfly.This flap should be completely open when the engine is at operating temperature open so that the air can pass through the throat of the carburetor freely. If you don't understand how a choke works go to howstuffworks and ask how a carburetor choke works and it will all make since.
the glow plugs are located inside the the valve covers on the engine' the wire harness goes thru the cover gaskets.so this is a major job.if you break a gasket while removing, they cost about $70 , each to replace. you also need special tools to remove glow plugs. it is much easier and safer to take the truck to a reputable diesel mechanic.
If the 360 is in a F100 the point gap is .021. If the 360 is in a F250 or bigger the point gap is .017.
4 gallons
10qts
It should be the 6.8 liter engine and the capacity is 6 quarts
what engine? most will be close to the t-stat.
6.0 gallons
That depends on which engine is in it. If it is the 6.0 Powerstroke diesel, the oil capacity is 15 quarts.
i have to change oil pump f250 351winsar.how topull the engine out?
The 1992 Ford F2 50 pickup truck 5.8 liter engine coolant temperature sensor can be found on the top of the engine. The coolant temperature sensor will be near the intake manifold.
If you are referring to the diesel engine, its capacity is 15 quarts, but if you are referring to the gasoline engine, the capacity is 6 quarts.
i have the same engine in a 1984 e350 and i get about 8
'03 6.0 takes 15 quarts. '04 should be the same.
sounds like a bad idle control sensor