Headlights Tail and Brake Lights
Saturn L-Series
Timing Belts and Chains
Ford Escort LX

What is the correct way to replace the third brake light in a 2004 Saturn L300?

151617

Top Answer
User Avatar
Wiki User
Answered
2006-04-22 10:50:17
2006-04-22 10:50:17

Easy! Just goto the 3rd brake light and carefully pull off the cover... CAREFULL not to brake the snaps... before hand though, you have to go to the dealer to get the LED's, see how many you will need.

001
๐Ÿ™
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


There was a manufacturing problem with the original equipment brake light sockets which allowed many to fail prematurely. Saturn attempted to replace all of the brake light assemblies through a recall campaign. If your brake light assembly has not already been replaced, contact your local Saturn dealer.

There is a campaign on the brake bulbs for 2000-2003......If it hasn't been done you should get it done. The bulbs and sockets will be replaced.

To replace the brake light on a 2000 Ford Explorer, remove the screws holding the brake light in place. Gently, but firmly, pull the brake light out of the vehicle and replace with a new one.

How to replace a brake light on a nissan Tiida hatch back.

To replace your brake light, you need to unscrew the brake cover from the inside of the trunk. Then you will be able to pull the old bulb out and replace it.

how to replace the brake light switch at the pedal of a 2001 ford zx2

how to replace brake light bulb fiat doblo van

Your brake light is probably brake fluid low or emergency brake on. Rear brake lights are replaced by removing the lens and replacing the dual filament bulb.

How do you replace the third rear brake light in a 2005 buick allure

Check the petal and make sure that the plastic part that touches the brake light switch when the petal is in contact with the brake light switch is still on the petal, if it is missing you will need to replace it, so the petal will make correct contact with the brake light switch.

Pull the carpeting behind the brake light. Unclip the assembly, replace bulb.

How do you replace the rear brake light bulb on a 2001 Honda civic?"

You might need to replace the back-up light sensor, located under the dash, by the brake pedal. The correct term is "brake light switch" instead of "back up light sensor." And yes, it is located above the brake pedal.

To replace the brake light bulb you need to remove the whole light assembly. Once removed the change is simple.

remove the 2 t15 screws in the taillight remove the assy. turn bulb socket out and replace

you have to pull the tail light all the way out.The 2 screws are on the inside where you open your trunk.

On the undwerside of the dash attached to the brake pedal.

How do you remove cover to replace brake light on 57 kia Rio

you need to replace the brake light switch that is located above the brake pedal underneath the dasboard Here's a link to a video that 1aauto.com has that shows you how to replace the brake light switch.

Replace bulb with correct type and check contacts inside of the socket and clean if needed.

Check the brake light switch on the brake pedal. Might have to replace it.

How can i replace my middle brake light on my 2005 kia sorento.

you have to replace the parking light bold because is the same as the brake light so just replace the light bold I think is the middle one between turning light and backing light. you have to replace the parking light bold because is the same as the brake light so just replace the light bold I think is the middle one between turning light and backing light.


Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.