How can I identify if my engine is a 350 or 327?
Engine block casting # 3970010
Vin stamped code 18l611487
thnaks,
Julio Zamago
3970010 shows up on both 1968 327's and 1969-79 350's
could be either originally.
without disassembly no way to really know for sure.
Look at your harmonic balancer the 1 on the 350 is bigger than the 1 on the 327.
Set the motor to TDC, pull the #1 spark plug, put a small wooden dowl rod in the cylinder, rotate the engine and measure the stroke. 3.25" = 327, 3.48" = 350
If there is no sticker present, there is no way unless you take it apart
327
yes just get head gaskets for the 350 not the 327
a 350 or 327 that is the question. A 350 or a 327
4.000 inches -- same bore size as a Chevy 350, the difference is a 327 uses a 3.250 stroke and the 350 uses a 3.480 stroke.
The Chevy 350 is 5.7 liters the 327 is 5.3 liters
The later 327's were exactly the same as the early 350's, so yes, a 350 crankshaft will fit a 327 block if it's a 1967 and up block.
Putting a 327 crank in a 350 makes it a 327. (3.25") You can't put a 327 crank into a 350 without changing the pistons. The piston would be 1/4" down in the hole, and would have very little compression.
Very hard to tell without pulling a head and measuring the stroke, but there are some signs that might help. If the factory intake has an oil filler tube and there are no bolt holes in the ends of the heads, it's probably a 327.
A 327 and a 350 share the same bore diameter (4.00"), but the stroke of the crankshaft is different. If you put 327 pistons on a 350 crankshaft it would put the piston 1/4" out of the hole at TDC.