The dist has to come out so bunp the starter so the rotor is pointing streight to the rear so you can put it back that way. Mark the distributer so it can be turned exactly like it is when you go back with it.Then remove the distributer and take the gear off of the bottom of the shaft noting that there is a indentation in the gear that is facing the same way the rotor is pointing. Then pull the shaft out of the dist after you have sanded the varnish off of the shaft so it will slide through the bushings.then r&r the pole piece which is on top of the pickup coil, and replace the coil. Then reinstall the pole piece and coil and go on from there making sure the pole piece doesn't hit the pickup points on the dist.. Check the timing when you all through although you shouldn't have to adjust it much if you did a good job of marking it when you remved it.
If you are asking about changing the ignition coil that is mounted on top of the distributor cap, it is held in with two screws and can easily be replaced.
This is the easiest question I have ever heard of. It's obviously state change!!?
Here is what i know the (CYP) cylinder sensor is deep in the distributer and the easiest way to fix it is, Change the distributer. !
No. It is possible to change direction without changing speed. However, it is not possible to change direction without changing velocity.
The answer depends entirely on how the dimensions change. It is possible to change the dimensions without changing the perimeter. It is also possible to change the dimensions without changing the area. (And it is possible to change the area without changing the perimeter.)
check the distributer or change the spark plug wires and spark plugs this happened to my try changing the moguel
The two are not directly related. You can change the amplitude without changing the wavelength, and vice versa.The two are not directly related. You can change the amplitude without changing the wavelength, and vice versa.The two are not directly related. You can change the amplitude without changing the wavelength, and vice versa.The two are not directly related. You can change the amplitude without changing the wavelength, and vice versa.
yes
sauravv
Chemical change
a physical change
Change it. Don't be a dumb.