Want this question answered?
6.5" round speakers.
Front of throttle body. All one piece, and wiring plugs in on passenger side
standing at the front of the motor it is on top on your right, it is a large silver cylinder held down by 4 bolts and it has rubber/alum. lines going to it.
It is on the right rear top side of engine, back right corner of intake. standing in the front of engine.
how to cahange front pinion seal
No. The pinion seal would be at the differential input.
how do you change front ring and pinion on 89 Toyota pickup
You probably mean the NOX sensor, it is the exhaust in front of the converter and the V8 has at least two of these sensors, easy to get to after you get under the truck, just unplug the wire and remove from the exhaust
Dont do it.... This is a clip job.. was popular a decade or two ago... Get a Mustang II kit from Chassis Eng in Iowa or somewhere else... Rack and pinion steering etc.. far better answer!
Front pinion. So you have 4wd. Its not the end of the world. Remove drive shaft. Bolts in the middle. Then remove the pinion seal. It will definitly suck on your back. Try to find a lift.
I need to replace the rack and pinion in a 1993 Nissan Altima.
There is either a problem with the actuator in the front differential--BAD ACTUATOR. Are there is a problem with the differential ---RING and PINION asembley.