answersLogoWhite

0


Best Answer

Well, you figure about 200 for the new starter and allow up 200 for labor. It depends on the stuff that has to be moved to get to it. Also depends on the area of the country you live in for labor rates. They vary. It is a little less if you get a remanufactured starter, but that is your call. Good luck.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the general cost to replace the starter on a 1998 Oldsmobile Intrigue?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Where is the starter relay located on a 1999 Oldsmobile Intrigue 3.5?

where is the starter relay located??


How do you replace a crankshaft position sensor on a 1999 Oldsmobile Intrigue 3.5L?

It is located above the starter. you must remove the starter for access. Make sure you disconnect the battery first.


Where is the crank sensor on a 2001 Oldsmobile intrigue?

just above the starter on the front of the motor. will have to take the starter off to get to it.


How do you change the crank shaft position sensor on an Oldsmobile Intrigue?

For 3.5l, remove starter.


Where is the location and how to replace a Starter Solenoid on a 1992 Oldsmobile?

Is there a picture of a Starter Solenoid for a Oldsmobile 1992


What does crankshaft sensor look like on 1999 Oldsmobile intrigue?

looks like a normal sensor, I have a 2002 intrigue, it is located just above the starter, you have to take out the starter in order to take it out.


Where can you find a step by step procedure for changing the starter motor on an Oldsmobile Intrigue?

try allexperts.com


Where is the starter located in a 1998 Oldsmobile Intrigue?

It is located under the motor, front and center. To access it, you must get under the vehicle.


Crankshaft position sensor 2002 Oldsmobile Intrigue 3.5L?

depending on the year, I have a 2002 intrigue, it is located just above the starter, it needs to be removed to remove the crankshaft sensor, 15mm for starter and 10mm for sensor 1 bolt , not to difficult.


Show you a diagram of where the crankshaft sensor is located on a 2000 Oldsmobile Intrigue?

Is this a 3.5L Intrigue V6 engine? If so, it should be behind the left exhaust manifold. You will need to remove the starter to gain access.


What would cause a 98 Oldsmobile intrigue from starting?

no gas entering piston chambers or no spark in the spark plugs. I assume the starter is spinning the engine?


Where is the crank shaft position sensor on a 1999 Oldsmobile intrigue 3500 engine?

The crank shaft positioning sensor is behind the starter. A real bear to get to.