0
What is the plug sequence on the distributor for a 1971 Chevy Blazer?
Wiki User
∙ 12y ago
What engine? V8? 18436572
for chevy 1991 silverado v8 350
diagram
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What was the first year of the Chevy Blazer?
It has been awhile, but I think it was 1971.
How do you fit a 1971 c10 Chevy hood on a 1991 Chevy s10 blazer?
Not possible without major fabrication.
Will a distributor from a 350 Chevy small block fit a 1971 442 350 rocket?
no
Where is the oil pressure sensor in a 1971 Chevy?
look by the distributor toward the driver side
What is the spark plug gap for a 1971 Chevy c20?
0.035 as long as it still has points and condenser type distributor in it.
How do you remove the ignition switch on a 1971 Chevy blazer without a key?
You would have to drill out the center of the lock or have a locksmith pick the lock.
Where On a 1971 Chevy do you set the distributor to the 1 plug or 1 on the cap?
be it a 4,6,or8 cylinder....be sure you have the crank on TDC, top dead center, install the distributor so that the rotor is pointing to #1 cylinder on the cap
What is the order of spark plug wires for 1971 Chevy Nova?
350 Chevy firing order and direction1-8-4-3-6-5-7-2 The distributor spins clockwise. Turning the distributor counter-clockwise will advance the timing AnswerListed on the intake manifold. The firing order is 1,8,4,3,6,5,7,2. 1,3,5,7 are on the left side (driver's) and the right side is 2,4,6,8. The distributor turns clockwise.
Which is the power of the engine and the maximum speed of the Chevrolet Blazer 1971?
The power of the engine and the maximum speed of the Chevrolet blazer 1971 is 55.5 bhp at 6 500 rpm. and 112 mph respectively.
Is it possible to remove a head without removing the distributor on a 1971 Chevy 350 v-8?
Well if you were working on an old ford engine you could slide the head out from under the intake with out removing it. But on a chevy you MUST remove the intake manifold to get the head off. Now that's means you would have to remove the distributor too be able to remove the intake. It can't be done CORRECTLY by leaving the intake on. SO NO.
Can a 1984 Chevy pick up motor fit into a 1971 Chevy?
Yep
Can you bolt a 1971 Chevy 350 to a 1986 Chevy 2.8 transmission?
yes
