answersLogoWhite

0


Best Answer

Sounds like the throtle position sensor is bad. Have it checked on a computer at a garage. The parts store computers cannot give good codes to narrow it down.

User Avatar

Wiki User

16y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What is the problem with a 1989 trans am v8 5.0l 305cid when the intake air control valve has already been replaced and the car is still idling at 2000rpms or more?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Why does power steering work turning to left but not right already replaced pump no difference?

The problem is your rack and pinion .


Emission control problem 1998 Jeep Grand Cherokee?

catlytic converter is plugged and needs replaced


Does the temp control need to be replaced in a 93 Cutlass Supreme when the air will only blow out the floor and a little at the windshield but not the vents?

the temp control is not the problem. the air direction switch is most likely to be the problem


Daewoo nubira veers to one side when accelerating?

I have a 2000 Daewoo Nubira and I had the control arm replaced and it fixed the problem.


Replaced battery and alternator on 97 mercury sable and it keeps stalling what is the problem?

Idle air control? Fuel pump? Coil?


Low beams on 1997 sunfire don't work and already replaced the switch 3 times?

the problem is the switches themselves, just poorly designed.


How do you fix a Honda civic with wiper motor that only runs on high?

i have the same problem, already replaced the switch. Its the motor. its around $90 new


Mazda mpv 2000 VTCS Fault?

There is one issue for this fault. The manifold runner control actuator needs replaced and this will solve the problem.


2000 sl surging and idling high?

I have the same problem. I believe the idle air control valve either needs to be cleaned or replaced.


Where is the turn signal control relay located on a 1998 Chrysler Sebring Coupe?

I have a turn signal light that keeps flashing regardless of the control arm position. I think that the problem is in the turn signal control relay but I don't know where it is located. I did find the 3 prong relay located behind the center console but this is not the problem because I replaced it and have the same problem.


Why did The right two gauges stoped working and the power to the ac go out on my 2000 Malibu?

I have a 2000 Malibu and I am having the same problem. There is an electrical problem. I have yet to figure out how to solve it, but turning on the AC blows the fuse. Ive had the instrument cluster replaced, so dont go and do that, because your car will still do the same thing. Your BCM (Body Control Module) may need to be replaced, or it is just a bad wiring. If you have replaced your battery, that may be a part of the problem. I know this information is not much, but hopefully it will help. I have a 2000 Malibu and I am having the same problem. There is an electrical problem. I have yet to figure out how to solve it, but turning on the AC blows the fuse. Ive had the instrument cluster replaced, so dont go and do that, because your car will still do the same thing. Your BCM (Body Control Module) may need to be replaced, or it is just a bad wiring. If you have replaced your battery, that may be a part of the problem. I know this information is not much, but hopefully it will help.


Why wont your ford excursion idle?

The idle control valve needs to be replaced. It's mounted behind the throttle body. Just replaced mine to fix same problem. Cost $65.00 at auto parts store.