what is the cam timing specification for mitsubishi 4M51 engine?
A 1979 Chevrolet pickup does not have a timing belt, it has a timing chain. The chain will last the life of the engine and is normally replaced during an engine overhaul.
The 3.0 liter V6 engine in a 1990 Toyota pickup has a timing BELT
wich engine do you have?
The timing chain does not have a recommended change interval and should last for the life of the engine.The timing chain does not have a recommended change interval and should last for the life of the engine.
On a 1989 Chevy Celebrity the timing is controlled by the engine control module, there is no specification or provision for adjusting the timing manually.
Outside the engine
No , it has a timing belt . Recommended to change every 90,000 miles . Also , it is an interference engine
timing CHAINAdded: Check the above answer out carefully - I have an '04 and my engine has a timing BELT. Recommended replacement mileage for the belt is 90,000 miles.
You do not have to do anything. It is recommended on some vehicles, but not many. Timing chains usually last the life of the engine with no maintenance.
The 2.5 litre V6 engine in a 1995 Ford Contour doesn't have a timing belt , it uses ( 2 ) timing CHAINS
separate a timing connector on the firewall in engine bay which allows you to time the engine,then adjust the distributor.The connector is on the drivers side below the cowl and when separated the engine will run differently.
It is recommended that you replace the timing Chang, on your Chevrolet Silverado pickup truck, at 60,000 miles. Many times the warranty is voided if the timing chain is not changed.
It has a timing BELT - recommended replacement mileage is 105,000 miles. CAUTION: This engine is an "interference" engine. If the belt fails while the engine is running it will cause major damage to the engine.
0 TDC / Top dead center.
No, this is not an interference engine.
First place there is no need to set the timing if the distributor has not been moved. And there is no wire to unhook.The ignition timing is controled by the ECM / engine control module. If the timing is off you will have a check engine light on. If the light is not on, then the timing is correct. No need to bother, The computer is taking care of it.You have to have a OBD II engine scanner to set the timing.
It has a timing chain. The timing chain is on the front of the engine. But before messing with it ,I would have the timing check first. You may have something else wrong,like a sensor or a vaccum leak.
It has a timing BELT. Ford's recommended replacement interval is at 120,000 miles.
Whenever you rebuild the engine.
The timing 12 degrees plus or minus 2 degrees. It's the third line from the left, when looking from the front of the engine. The timing is 12 degrees plus or minus 2 degrees. It's the third line from the left, when looking from the front of the engine.
In a 1990 Dodge Ram 50 pickup both the 2.4 litre four cylinder engine and the 3.0 litre V6 engine uses a timing BELT
on the front of the engine behind water pump (water pump is bolted to it )
A timing chain should last the life of a engine. The smaller engines with rubber timing belts have service replacement intervals.
Timing on a 1987 thru 1990 Chevy Celebrity 2.8/3.1 engine is controlled by the ignition control module along with the engine control module. There is no provision or specification for manually adjusting the timing on these distributor-less models.
Ask questions, submit answers, leave comments
Earn points for using the site
Customize your profile
Already have an account? Log in