i usually follow the picture when you get the head gasket. failing that, i start from the centre head bolts and go around in a clockwise direction working outwards. some people suggest using a star pattern like doing up wheels but it's too easy to forget where your up to unless you use a pen marker to remind you which ones you have tightened.
The Honda had bolt tightening sequence begins with the head bolts on each end of the head. Tighten the head bolts moving to the center, alternating from and to end.
The cylinder had bolt tightening sequence should begin by tightening the head bolts on each end of the head. Tighten the center head bolts. Work towards each end of the head, alternating back and forth.
The tightening sequence for the head bolts on a Peugeot 106 1.1 is to begin at 1 and of the head. Move to the opposite end of the head. Alternate back in forth until you reached the middle.
Begin by tightening the head bolts on each corner of the head. Next, tighten the center head bolts. Tighten the bolts on each end of the head and move towards the center.
What are the torque specifications and the tightening sequence of the cylinder head bolts on a 1996 Saturn SL1?
http://wiki.answers.com/Q/What_are_the_torque_settingsand_tightening_sequence_for_the_cylinder_head_bolts_on_a_kia_sedona_2.9 the cylinder head bolts on a kia sedona 2.9?"
20nm +180 degree +180 degree
Use new bolts. Apply a light coating of engine oil to the threads of the new cylinder head bolts. Install the new cylinder head bolts to the cylinder head. Tighten the cylinder head bolts to 40-60 Nm (30-44 lb-ft). The sequence is to start at the middle bolt on the intake side of the head, then move to the exaust side, then move out to the ends of the head in a criss-cross pattern. Loosen all cylinder head bolts approximately two turns, then retighten the cylinder head bolts to 60 Nm (44 lb-ft). After tightening, turn all bolts 90 degrees, in the same sequence. Complete bolt tightening by turning them an additional 90 degrees, in the same sequence.
45,65,65 ft lbs then 90 degrees.
which one? The head bolts? Engine to transaxle? And, are you really asking what the tightening sequence and/or torque rating is?
Pls let me know the cylinder head bolt tightening sequence for toyota cressida mx83
head bolt sequence Toyota tercel