0
220-281 Ft Lbs
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
What is the pinion nut torque on a 1999 Chevy blazer?
There is no specific pinion nut torque. The pinion nut has to be tightened until the proper pinion preload is established. Pinion preload is what matters
Nut torque on pinion nut 2007 dodge 1500?
Torque specs on a 2007 ram pinion
Pinion nut torque on 2001 Chevy truck?
There is no specific pinion nut torque that needs to be reached.. You just need to tighten the nut until the correct pinion preload is reached.
What is the rear differential pinion nut torque specs?
What is the torque specs on a 2001 ford truck rear end pinion nut..
Lug nut key for 1995 Isuzu Trooper?
What about it.
What is the rear differential pinion nut torque spec Toyota 8 inch?
I don't believe there is a specific torque specification! Once you install the crush sleeve and tighten the nut to the desired preload on your pinion bearings, your torque will be what it will be.
What are the torque specs for the pinion nut on a GM 8.5 3.42 rear end?
The General Motors 3.42 rear end pinion?ænut torque specification is 240 pounds. The pinion nut should be torqued in 80 pound intervals.
What is the torque on a 1998 dodge 1500 pinion nut?
i think 210
Changing rear differential pinion seal on 2003 dodge quad cab 1500 and the torque specs for pinion nut?
210ft. lbs.
What is the torque for the pinion nut on a 68 Camaro 10-bolt rear end?
There are a couple different methods to correctly torque the nut on the pinion. One way that I have used in the past with excellent results,is to tighten the pinion nut real good and snug just as you feel the crush sleeve begin its resistance,and then you actually place an "inch pound" torque wrench(Dial or Bar style tends to be a little quicker and more exacting than a click style) with correct socket on pinion nut and rotate the pinion by way of the smaller torque wrench (ring gear and carrier removed).If the inch-pound torque wrench doesn't click before the pinion rotates(inch-pound wrench set approx @12-15),then snug the pinoin nut up with your 1/2 drive impact more.Tighten nut in SMALL increments.Dont overshoot it,other wise you run the risk of wasting the one time use crush sleeve and burning up the pinion bearings.If say the wrench clicks @10,11,12ish before the pinion rotates,but if set @ 15 or so,and the pinion rotates before the torque wrench clicks, you are in the right area.What you are doing is measuring the amount of "rotational drag" on the pinion with the inlb torque wrench.Another way is if the crush sleeve is replaced with a solid spacer,the nut can be torqued down with a regular pop wrench to about 60-75 ft/lbs.
1996 ISUZU NPR lug nut torque specs?
325 ft. lbs
What is 1995 Ford pick up with traction lock rear pinion nut torque?
The only torque you should be concerned with is the torque it takes to rotate the pinion gear alone, 8-14 inch pounds for old bearings, 16-29 in/lbs. for new bearings. The torque it takes to crush the crush collar (tightening the pinion nut) will be above 140 foot lbs. and this will set your tension on the pinion bearings. If you put a new crush collar in you are going to have to remove axles and carrier to get the proper pre-load on the pinion bearings.
