Want this question answered?
on f150 19998 stud nuts
pple ball is heavy
100 psi if you are talking lug nuts. Pretty vague question.
50 grams of nuts is 1 3/4 ounces of nuts.
I cup of macadamia nuts is equal to 1 cup US 134 grams. One serving of macadamia nuts has 2.6 grams and is 7.8 nuts.
on f150 19998 stud nuts
remove the attaching nuts, and with a ball joint removal tool, remove old link. Then install new link, and torque new nuts to specs.
Begin by removing the tire and wheel from your Kia. Remove the ball joint retaining nuts. Pound the ball joint out with a hammer. Reverse the process to install your new ball joint.
Have the vehicle checkout, a ball joint should not make the car shake ( There are other components that would of been removed to change the ball joint. There is obviously something lose or installed incorrectly. Check the torque of the wheel nuts as a lose wheel may be the culprit. There is a possibility of steering or suspension failure, DO NOT drive the vehicle until it is repaired.
once have ball joint loose have to drill/remove the rivits holding it in, will be replaced with bolts/nuts
Remove the tire and wheel from your 1996 Mercury Grand Marquis. Remove the ball joint retaining nuts. Pound the ball joint out with a hammer. Reverse the process to install your new ball joint.
Begin by removing the tire and wheel from your 1992 Mitsubishi. Remove the ball joint retaining nuts. Pound the ball joint out with a mallet or hammer. Reverse the process to install your new ball joint.
Ball joint. Shake your tire if it wiggles a lot you need a new ball joint. possible you need to tighten your lug nuts
if it is original the upper ball joint is riveted in, it will need to be chisel out,there are four rivets and then the nut that holds it to the control arm.new ball joint will come with bolts and nuts
first , remove the wheel . then unwrap the cotter pin on each of the old ball joint nuts and remove the nuts . hammer upward or downward on the top and bottom (respectively) ball joint shaft to remove them from the steering knuckle . then remove the circlip from each ball joint using ring-opening pliers . finally , use a ball joint press to remove the ball joints from the upper and lower control arms . install the new parts where the old parts were .
Raise and support the vehicle and place jackstands under the cradle. Vehicle weight should not be placed on the control arms.Remove the wheel assembly.Install drive axle boot protectors.Remove the cotter key from the ball joint nut and, using a ball joint removal tool, separate the ball joint from the steering knuckle.Drill out the ball joint retaining rivets. It may be necessary to chisel the drilled out rivets out of the control arm, even after drilling them "out."Remove the stabilizer bar bushing to control arm bolt.Pull the control arm downward and remove the ball joint from the steering knuckle and control arm.Reverse procedure to install. Torque the new ball joint attaching nuts to 50 ft lbs . The ball joint stud nut should be torqued to specifications, about 64 ft lbs.
The CV joints on a 1995 Ford Taurus can be replaced by removing the front tires, and the nuts on the lower ball joint. Next, the lower ball joint will need to be removed and the CV joint can be removed.