0
What is the torque sequence for a 2000 5.7 intake manifold?
Jlhooker
Start on the inside do an X pattern and work your way out
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
Intake manifold bolts torque ford windstar?
2000 3.8 Lower intake manifold (manifold to cylinder head) 1st step is 44 inch pounds, 2nd step is 89 inch pounds. This must be done in sequence.
Can you show a pic of where the bolts for the intake manifold are on the ford expedition 2000?
Here is a link that shows how to replace the intake manifold gasket. Bolt locations and torque settings. Hope this helps.
What are Torque specs for buick century 3.1 the plenum?
Correct torque on 2000 model : 18 Ft. lbs.- upper intake manifold [ plenum ].
What is the Torque sequence of a 2000 Chevy 4.8L Intake Manifold?
There is no set torque sequence. Usually, starting with the bolt at the 12 o'clock position, then move to the 6 o'clock, then 3, then 9. Then move to 1, 7, 4, 10, and continue in a clockwise manner until 12 o'clock is reached again. The torque amount for a Silverado is 44 inch pounds on first torque, and?æ89 inch pounds the second time.
Cylinder Torque sequence 2000 Pontiac Montana SV6?
What is the Cylinder Torque sequence 2000 Pontiac Montana 3.4V6
Where does the vacuum hose on the intake manifold on a 2000 Malibu go?
I have a 2000 Malibu, I can help you out if you can give me some more info...where on the intake manifold are you referring to?
Where is the upper manifold gasket located on a 2000 Chevy s10?
Assuming this is a 4.3L engine, the upper intake manifold gasket would be between the upper intake manifold and the lower intake manifold.
Where is the intake manifold on a 2000 venture?
on top of the motor
What is the torque spec on an Edelbrock aluminum intake manifold for a 78' ford 400m?
Here is the installation instructions for the Edelbrock Performer aluminum intake manifold for a Ford 351M/400...hope it helps out. http://www.edelbrock.com/automotive_new/misc/tech_center/install/2000/2171.pdf
Where is the intake manifold re 2000 maxima?
the intake manifold is located on top of the engine, the piece that look like the tubbing is intertwining.
What happens when the intake gasket go bad in a 2000 olds bravda?
your oil and coolant mix. then you have water in your oil and it makes a white grease. Then the engine will seize if you don't do anything about it. The gaskets is like $30, To put on a intake manifold you need a torque wrench, torque spec and torque sequence. Go buy yourself a Chilton or Hayes manual for you car and read it. If it don't cover it completely, read more and apply what you know and fix the car to your capabilities. Or go spend a lot of money not to get your hands dirty
How do you fix intake gasket on 2000 lasabre?
The only fix for a bad intake gasket is to remove the intake manifold and replace the gasket.
