On a Dodge truck, the vacuum switch is on the transfer case.On a Dodge truck, the vacuum switch is on the transfer case.
OC stands for Open circuit and means you must replace the sensor mounted at the front of the truck. Easy fix as it is in the middle of the truck by the hood latch in front of the radiator. It has a connector inline.
Does the truck have stock discs? Why would you want to switch the discs back to drums? Does the truck have stock discs? Why would you want to switch the discs back to drums?
It's the one closest to the crankshaft pulley, or the front of the engine, the front of the truck. Assuming it's an inline engine, not a v.
You probably have a bad front tank fuel pump or you could have something wrong in the switch valve or selector switch, or even a problem in the wiring to the front fuel pump, but most likely a bad fuel pump.
The 1998 Ford F1 50 pickup truck neutral safety switch is located on top of the transmission. The neutral safety switch will be near the front of the transmission.
truck has a bad fuel switch
Pull the front dash bezel out that surrounds the cluster and the radio and the a/c-heater controls out and then remove the controller and replace the switch.............
A truck is normally driven from the front.
It is just under the front of the dash, But on the top side of the steering shaft under the dash.
Check fuel filters
you can see the front of the truck in your rear-view mirror.
It is wired inline with the Crank wire going from the ignition to the starter solenoid located on the starter. Clutch up --> open switch (no start); Clutch down --> closed switch (start) Very basic for this year of truck.
235 Cubic Inch Inline 6.
If the Actuator was not working then the front wheels would not pull at all.There is nothing wrong with your truck or the 4x4 SYSTEM.No Factory 4x4 truck has positive traction in the front, what you are complaining about is normal, both front wheels don't pull at the same time. They switch back and fourth, and it makes it fill funny, The steering wheel jerks around.YOU HAVE NO PROBLEMS. NEUTZ
yes ,but the motor mounts are probably different
No such switch.No such switch.
In the right front passenger footwell , by the kick panel
insert ignition key into passenger airbag slot on the front dash and turn to off
Mazda truck b3000 where is the fuel pump reset switch located
it does not have an inertia switch.
Short to power in the horn circuit, relay stuck in the closed position, stuck horn switch.
2 wheel drive or 4 wheel drive? It makes a difference.
The oil pressure switch is located at the back of the engine next to the distributor. Looking at it from the front of truck it will be right of distributor. Normally it can be changed without removing the distributor.
Probably a bad ignition switch.