U need 2 spray the inside of the power door lock switch with electrical contact cleaner or repair the loose connection on the back of the switch
Press UNLOCK on your key fob twice
No
If it won't unlock with the key, this means that the rod from the key tumbler to the door latch has become disconnected or is broken. If you can get the door open, you will need to remove the inside door panel and look in through the holes to see what the problem is.
1. Close all doors2. Insert key into ignition3. Hold down the power UNLOCK button on the driver's door panel, continue to hold downuntil instructed to release in step 9.4. Perform steps 5 through 8 in a fairly rapid succession.5. Turn the ignition to the ON position (as far as you can go without starting the engine.)6. Turn the ignition to the OFF position.7. Turn the ignition to the ON position (as far as you can go without starting the engine.)8. Turn the ignition to the OFF position.9. Release the power UNLOCK button on the door panel. The vehicle should respond bydoor locks locking and unlocking automatically. (If locks do not cycle after you let go,not before you let go of the unlock button, then the vehicle has not entered programmingmode and you must start procedure over. Remove key from ignition, open drivers doorand return to step 1 ). If the locks do cycle automatically then proceed to step 10.10. Hold down the LOCK and UNLOCK buttons on the remote until the doors lock andunlock. This may take up to 30 seconds.11. Repeat step 10 NOW for each additional remote. (Including any existing remotes).12. Turn the ignition to the ON position to exit the programming mode.13. Test remote(s).
PULL UP PASSENGER SIDE HANDLE AND HOLD IT UP WHILE YOU TURN THE KEY IN THE LOCK EITHER LEFT OR RIGHT........I DONT REMEMBER WHICH WAY THIS WILL UNLOCK THE DOOR ....DEPENDS ON THE YEAR
I think you have to push the 'unlock' button twice in order to unlock the doors.
Hook up a meter to either the lock wire or unlock wire, press the lock button and the the unlock button. you will see the meter go to 12v on 1 press and open circuit on the other. if its just 12v and ground, then its positive polarity door locks.
You click the crate and select the Get Help button on the bottom and publish it and your friends will help unlock it...
It should lock and unlock with the power door locks. If it is stuck in the locked position, there is a lever in the trunk on the driver's side behind the carpet that will unlock it.
Depends on what part of the locks are not working.. the remote?, the lock button?, a certain door?, the manual lock slider?
If the locks and rear window hatch on a 1998 Chevy Blazer lock and unlock by themselves, there is probably a problem with the fuse or a short somewhere. The locks are supposed to lock when the vehicle gets put in gear. Perhaps the system that tells the locks when to lock is not working properly.
you need to get in your Tahoe 1. put the key in the ignition 2. hold down the unlock button 3. continuing holding down the unlock button, turn the ignition on, then off, then on, then off again. 4. Release the unlock button(The Locks shoul lock then unlock) 5. Press the unlock and lock buttons on the remote at the same time and hold for 15 seconds if you have done it right after 15 seconds the locks should lock then unlock and your remote is programmed after this turn the key to the on position to exit program mode
I'm having the same problem. Relays working fine and door locks have some movement, but do not lock or unlock all the way. Hope we find out the problem.
Same problem, but didn't replace the dome light.The locks will unlock but not lock.
1. Insert key 2. Hold down drivers side unlock button 3. Turn ignition to on position and back to off position three times (on,off,on,off,on,off) 4. release unlock button. (door locks will cycle) 5. hold down the lock and unlock buttons on the remote at the same time. (locks will cycle again) 6. Remove key, the remote should now work (unless is is not the right frequency for your car, in which case the locks wouldn't have cycled the second time)c
Possible the system is deactivated. 1. Sit in the driver seat, turn the key on. 2. Hit the unlock doors button 3 time (within 5 sec of each other). 3. Turn the key off and hit the unlock 3 times again. You should get a chirp from the horn. If this does not solve your problem, you can try the same proceedure but hit the Lock button Vs the unlock button
Should be a button on center console..Just underneath hanbrake button.