Try the fixes offered in the "Related Question" below... Chances are really good they'll work for you.
When the signal lights are not working on a car, there are a couple of things that could be going on. One could be that the bulb needs to be replaced. The other possibility is that the signal relay needs to be replaced.
Had short in trailer light, blew fuse, checked traile, thought fixex, did not, blew turn signal fuse along with emergency flasher fuse, checked again, found problem, but no lights, replaced fuses, nothing works, have checked everything I know, even pulled stering wheel checked swith, nothing wrong, has me at wits end, plesse advise
have you checked the fuses?
The whole turn signal arm unit needs to be replaced
check the ground on your tailights R.W: Have you checked the turn signal switch? That may have to be replaced.
I had the same problem with this and with mine I found out the curcuit board on the back of the taillight needed to be replaced. If you have a late model get it checked out.
The Turn Signal Switch is bad in the column and needs to be replaced.
they could have burned out, or the wires are bad. I recommend getting it checked by a mechanic ;)
If neither signal light works, the flasher may very likely be the problem. The hazard lights and the signal lights work off different flashers.
To replace turn signal control module requires removing steering wheel. Took mine to a dealer - $245 out the door. Brake lights work great now.
Have you checked the bulbs themselves? The directional signal should be the same element as the brake light. Check to see if you rear directional signals.
Turn signals just quit working- have replaced flasher- checked all bulbs and fuses, checked all obvious wires, cleaned grounds, replaced the turn signal switch (that was an adventure). At a loss- any help out there? Hazards work fine- all other lights work fine- turn signals dead
It needs checked out but both the hazard and brake lights go through the turn signal switch.
signal lights not working.
fuses are ok. replaced ignition multifunction switch and hazard, turn signal, cruise etc. switch. checked grounds. hazard lights when ignition is off but not in the on position. thanks Joe lapointe
If you have the same bulb for brake and signal, brake light power needs to be interrupted by the signal lights, The brake circuit has to go through the signal light switch so the problem could be there.
Probably the flasher unit needs to be replaced. This is an electronic switch which usually mounts underneath the dashboard.
I just replaced my bulbs and I also have the same problem. I have a 99 Toyota Camry and replaced with 7000k Xenon bulbs? Have you found the solution yet?I had the same problem with my 94 Nissan Pathfinder, the turn signal switch needs to be replaced. I didn't find this until all my lights went out including my dashboard and the low beam was the only lights working.
turn signal switch needs replaced!
It's the turn signal switch at the steering wheel, that is the problem. Very exspensive to get replaced,and to hard for an amuture to do. If you have checked all fuses and bulbs sounds like ur turn signal switch in ur steering wheel. I had the same problem and was switch.
The front or rear turn signal flasher bulb may be burned out and needs to be replaced. The turn signal flasher my be defective and should be replaced. The hazzard lights have a flasher unit of their own. These are found up in under the dash in the steering column area.
have your day time running light module checked the same thing happened on my car
Some cars have two flashers, one for the signals and the other for the emergency flashers. Be sure you replaced the right one. Also check the fuse the bulbs and lastly the signal switch.
I am assuming you have replaced any defective bulb. If none of the turn signals work, replace the turn signal flasher relay.