Want this question answered?
I have the 2000 model are you talking about rev/neu/ drive/ park gears?
If you mean the belt fell off the gears while the engine was running, you will have to replace the cylinder head. This is a zero clearance DOHC motor. When timing jumps, slips, or belt slips or breaks, you WILL have broken valves. Be prepared for a lengthy search---even for a salvaged head---Daewoo parts are becoming scarcer by the day---good luck
water pump is not driven by timing belt. The belt you see is your serpentine. Your timing belt is sealed. I believe you have an interference engine.. timing belt or chain drives your intake and exhaust gears for your camshafts
Unfortunately, you can't change gears on bikes in HeartGold.
The crankshaft position sensor is located behind the cam gears. you have to remove the timing belt to get to it. If your not having any problems don't fool with it. This is actually the camshaft sensor, the crankshaft sensor is down near the crankshaft and is the wire that runs up over the timing belt inside cover. It is very hard to reach and not many diagrams on it.
You have to change the gears
Gear changes are determined after how fast the engine is turning. For each gear there are set limits for which engine revs that are allowed. if the revs go high, the transmission changes up a gear, if the gears go low it drops down a gear.
Bevel gears can change the speed and motion and Worm gears can reduce speed and direction of motion.
how do you get to the gears on a johnson 50 hp marine
no u hav 2 change gears when the car is on its time to get a new car if this is the case
You change the ring and pinion gears
Check the hydraulic fluid reservoir for the clutch master, it may be low/empty. Filling it may get you by for awhile but you probably have a leak in the system and it should be fixed.