Check engine light and improper shifts.
On a Dodge/Jeep it is inside the transmission on the valve body.
It doesn't have a governor pressure sensor. The "rev" limiter is part of the computer programming and can not be changed.
It is inside the trans, on the valve body on the passenger side
Inside the trans, on the side of the valve body.
The governor pressure sensor is located within the transmission's fluid pan. It's mounted on a bracket with three 11 mm bolts and two #25 torx screws. This was on a '99 Dodge Durango with a 5.9 L motor.
It is on the passenger side of the valve body, inside the transmission.
It is inside the trans, on the valve body on the passenger side.
Trouble code P1762 means: Governor pressure sensor offset improper voltage Replace the sensor
Some will run rough and not run at all.
This transmission uses an electronic governor. The pcm is the control. There is a solenoid and a pressure sensor on the valve body inside the pan.
crank sensor in 2000 dodge neon fails. car starts to stall while operating. idols with no problem, when in operation starts to stall again and again until will not start again.
If you are asking about the code "governor pressure offset voltage" the governor pressure transducer is located on the valve body inside the transmission pan.