Wow....I feel silly, the bolts are so easily accessable on the other side!!! Oh, well..seems I need to clean away the oil and grime
disconnect battery. remove cables at the starter. remove starter mount bolts. remove starter. replace starter. reinstall bolts. reinstall wires. reinstall battery cable.
how to remove a starter on 2000 dodge caravan
Disconnect battery negative terminal, drain primary chaincase, remove left foot board & its rear bracket, remove outer chaincase cover, remove jackshaft end screw, disconnect positive terminal & solenoid terminal from starter, remove two allenhead starter mounting bolts, lift out starter. To reinstall starter reverse procedure.
remove belt, remove alternator plugs, then bolts. pull out alternator. then undo bolts for bracket and remove.
FIRST REMOVE THE WHEEL.THEN REMOVE THE TWO BOLTS HOLDING THE CALIPER TO THE BRACKET.THEN REMOVE THE TWO BOLTS TO REMOVE BRACKET. REVERSE TO REINSTALL.
To remove a starter from a 2003 VW Beetle, first you need to disconnect the battery. Then remove the bracket holding the wires, remove bolts mounting the starter, and take it out.
on my 1990 with 3.0 L, behind starter. remove starter to access unit
Is this the airplane? Remove one battery post connector. Remove wire connections from starter. Remove mounting bolts. Remove starter. Clean the bolts and starter hole of any dirt or grease. Install new starter with cleaned bolts and reinstall wires and battery connection.
First remove the battery from the vehicle. then remove the two 10mm bolts on the top side of the battery tray and the one on the bottom side and remove it. remove the positive wires from the starter. the nut is a 12mm. there are two 12mm bolts that hold the starter bracket to the top of the transmission. remove them. if it is a manual trnsmission, remove the two 12mm nuts hold the clutch cable in place. this is so the bracket on the starter will clear the cable with ease. then remove the two 14mm bolts holding the starter in place.
Disconnect the negativebattery terminal, starter is accessible from under the car passenger side, it bolts into the transmission with 3 bolts. Disconnect the wires from the starter, remove the bolts and reinstall new starter, reconnect wires.
Disconnect battery negative terminal, drain primary chaincase, remove outer chaincase cover, remove jackshaft end screw, disconnect positive terminal & solenoid terminal from starter, remove two allenhead starter mounting bolts, lift out starter. To reinstall starter reverse procedure.
Remove negative cable from battery Disconnect positive cable from starter and ignition wire Loosen mounting bolts from starter Remove starter Install new starter in reverse order of removal