My Preference would be a 600 Edlebrock, but for those who like Holly's a 650 with vacuum secondaries would be good too.
-Josh
get long tubes no matter what but hooker seems to be the way to go with those motors
Valves need adjusting or they are dirty or worn. Cherokees are notorious for having cracked exhaust headers, which would also make a ticking noise.Its probably the lifters.
The headers would be the same anyway, so you can order headers for the 83 and be all set.
Well I get bored a lot so what i do is play sports or walk to a store or go hang out with friends. Also you can go on youtube and watch funny video's i would recommend fred
I'm sure it can be done and I would go to a place that bends their own pipes and have a custom system made.
Yes , you would have to unbolt the headers from the cylinder heads
To adjust the valves on a Chevy Celebrity 2.5L 4 cylinder engine I would recommend that you consult a manual, either factory or Chilton or Haynes. There you will find not only how to do the adjustment but the settings to use to adjust the valves in the correct closed position.
no.
A good music class for any toddler would definitely be the piano or clarinet. They are easy to teach, i would recommend you take group classes where toddlers can also have the chance to socialize.
If you think about it yes they would cause headers flow better but when I say they will I'm not sure how much louder they will make your vehicle.
i would go with either DCsports headers or Megan racing headers. but both run pretty pricy
2 ways. Easiest way: Remove the inlet manifold...should be alot of m6 torx bolta holding it. Then you unscrew all the 10mm brass nuts you find on the orginale header. Then you remove the two springs holding header to exhaust system. Then take the old one out... Install the new one ..remember to put new gaskets between headers and inlet manifold. You might have to weld or change the exhaust to make it fit the new headers. Would recommend using Supersprint headers with exhaust wrapping on it. Good luck