answersLogoWhite
Transmissions and Drivetrains
Chevy Silverado
Chevy S-10
Ford Bronco XLT

What transmissions came in a 1991 S-10 4x4?

202122

Top Answer
User Avatar
Wiki User
2007-03-23 03:05:54
2007-03-23 03:05:54

a 700R4 more than likely... i have plenty in stock.. Macs Transmissions (Houston, TX) 281-394-4951 Macstransmissions@gmail.com

Related Questions

User Avatar

The fan clutch and pulley are attached to it.

User Avatar

gm says 96 and 97 are identical and can be changed back and forth

User Avatar

According to Drivetrain here is what fit for an Automatic S10, S15, Jimmy, Sonoma | 1991-04 | L4 2.5L; V6 4.3L | 4 Spd RWD/4X4 | 4L60E Manual Transmission NV3500 See links to confirm. Hope This Helps.

User Avatar

depends..if the tranny came out of an s10 with 4.3 yes..if it came out of an s10 wih a 4cyl. probably not..

User Avatar

you can do anything if you want it bad enough. but yes you can. the 1985 S10 4x4 blazers came with 4 cylinder engines. I know because my parent bought one. it was sorely under powered though.

User Avatar

The 1991 Chevrolet S-10 Blazer 4x4 with the 4.3 liter V-6 has a gross vehicle weight rating of 5,099 pounds. Its curb weight is 3,721 pounds.

User Avatar

If it starts up in any gear, manual transmissions does not have a neutral safety switch.

User Avatar

i am looking for a diagram of the firing order in a 1997 Chevy s10 blazer 4x4.

User Avatar

They are pressed into the block; there might be a bolt also holding them in place to the side of the motor.

User Avatar

A 1987 s10 Blazer 4x4 weights around 10.6. This is going off curb weight.

User Avatar

Is the S10 a 4x4?If not, measure everything and if it is correct Go for it

User Avatar

the 4.3l came with the ever popular 4L60E in 2wd vehicles, this is a computer controlled transmission and is usually slave to the ECU.

User Avatar

how do you change the oil pump on a 1991 s10 pickup

User Avatar

Will a 2000 blazer transmission fit a 1998 s 10 chevy 4x4 truck

User Avatar

The idle sensor on a 1991 S10 4.3 can be located at the engine bay.

User Avatar

The torque specs for a 2003 Chevy S10 4x4 wheel bearing is 28 ft. lbs. This is equal to 38 N.m.

User Avatar

No, you can't. transmissions bellhousing is different in 60° V6 and L4


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.