May only be able to fit in an open end wrench.
Any type of socket can be used to remove a 91' Cavalier wheel cylinder bolt that looks like a reversed torx. However, make sure the socket is a bolt head socket.
It takes a 12 point 12 mm socket
My 1997 Chevy Cavalier with 2.2L motor used a 15mm socket.
T-55 Torx Socket (DO NOT USE AN ALLEN WRENCH) - To remove the 3 bolts that secure hub assemble to steering knuckle. 1 -3/16 deep socket - To remove axle spindle nut.
Remove the water supply hose from your 1988 Chevy Cavalier thermostat housing. Remove the thermostat housing bolts. Lift the old thermostat out and drop in the new thermostat.
Remove bolts from inside of glove dep. Remove bolts under defrost vent. Remove bolts from panels on side of dash. I think there is a total of 6-8 bolts.
10mm 12-point socket
The 2002 Cavalier 2.2 liter engine cylinder head bolt torque specification is 120 pounds. The cylinder head bolts should be torqued in 40 pound intervals.
Put a length of steel pipe over the end of the socket handle, so you get more leverage. Pull steadily, with no jerks.
Remove the wiring harness from your 1988 Chevy Cavalier fuel pump. Remove the fuel lines from the fuel pump. Remove the fuel pump retaining bolts. Reverse the process to install the new fuel pump.
The 1997 Chevy Cavalier dashboard is held in place with for retaining bolts and eight retaining clips. Remove the retaining bolts and pry outward on the retaining clips.
remove rear wheel, remove brakes and cylinder is held on by 2 bolts from back of plate. remove bolts and brake line from cylinder !! somtimes you can take top nails holding brakes out to allow room to remove cylinder.
The 2000 Chevy Cavalier windshield washer tank is held in place with for retaining bolts. Remove the retaining bolts and the windshield washer tank will come out.
Snap-on socket # SLEPL 200
I think it`s a T60 obviously i/2 " inch dr
It is located under your coil packs and module us a 5.5 mm socket and remove the four bolts holding the coil packs on and then you can get to it and it take a 8 mm to remove it
The 2000 Chevy Cavalier cooling fan shroud is held in place with 10 retaining bolts. Remove the retaining bolts and the cooling fan shroud will come off.
You can remove the windshield washer fluid tank from your 2001 Chevy Cavalier by removing the retaining bolts. There will be for retaining bolts at the bottom of the windshield washer fluid tank.
Remove the serpentine belt and remove the alternator. The belt tensioner bolts are under the alternator.
Remove the positive cable from your 1998 Chevy Cavalier battery. Remove the cables from the front of the starter. Remove the starter retaining bolts. Reverse the process to install your new starter.
the thermostat is to the right of the engine, mounted on the right side of the cylinder head. you need a 10 millimeter socket to remove the three mounting bolts. torque for the bolts during reassembly is 7.5 ft. lbs. the housing for the thermostat is a rounded or dome shaped aluminum piece with an upper radiator hose attached to the right of the housing.
Mazda main fuse is bolted in with two M10 bolts. I know because I destroyed mine while trying to remove it. You will need a good socket set with a universal joint to remove it.
You need an 8mm hex socket and a 12mm socket. Remove the belt 14mm socket on the tensioner...Then remove the 8mm and 12 mmm bolts and it comes off