Clockwise to tighten, counter to loosen.
M14x1.5
22mm
loosen the center bolt and get your self a harmonic balancer puller just make sure you loosen the center bolt enough but not too much but you need a balancer puller.
Standard.
lefty loosey righty tighty:)
it has a key in it.
yes
The flywheel has to be held in place by a holding tool, Remove the mounting bolt, then use a balancer remover to pull the harmonic balancer.
The crankshaft pulley unbolts from the harmonic balancer. The harmonic balancer can be removed from the crankshaft with a 3 bolt puller.
first remove serpintine? fan belt then remove large bolt in middle of harmonic balance. this bolt usually has left hand thread next with a harmonic pulley ,puller, remove harmonic balancer.when removing this, there is a key in the balancer and shaft if a new key did not come with new balancer,make sure not to loose the old one install new balancer with key.use the bolt to pull balancer up tight where it needs to be and use proper torque on bolt
between 150-180. anywhere in that area is fine
The harmonic balancer is attached to the crankshaft using a Woodruff key or a square key and center bolt.