0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Which way do you turn to loosen gas pipe in barbecue?
propane tanks have left-hand threads.
Which way do you turn the harmonic balance bolt on a 95 Geo Tracker to loosen it?
which way do you turn the harmonic balancer bolt on a 95 geo tracker to loosen it
Which way do you turn the fan clutch bolt connected to water pump to loosen it on a 2000 Chevy s 10?
It turns to the left.
Easiest way to replace alternator belt on a 1994 Toyota 4x4?
Loosen the tensioner bolt on your alternator. Slide the alternator to the left. Remove the alternator belt. Put the new alternator belt on and tighten the tensioner bolt.
What way does the bolt turn to loosen on a 2001 dodge ram cooling fan?
Gas engine is counter clockwise to loosen. Diesel engine is clockwise to loosen.
Is the bolt for the idler pulley right or left hand thread in a 1999 Pontiac Montana The box says it can be either and it seems to tighten up either way it is turned?
Turn it left to loosen, and do NOT overtighten because you don't want to ruin threads (they may be damaged if last person that installed pulley over-tightened it).
When replacing the belt tensioner which way do you turn the bolt?
Anti clockwise is a normal bolt removal procedure. Does it have an "L" stamped on it? - meaning it's a left hand thread and removal is clockwise.
You are having trouble getting the front wheel bearing nut to loosen?
make sure that you are turning the right way to loosen nut. a lot of vehicles have left hand thread on wheel bearing nuts on one side of vehicle,and right hand thread on other side
Which way do you turn the bolt on the axle that holds the drum and rotor on?
RIGHTY TIGHTY - LEFTY LOOSY - unless its has backwards threads (left hand)
Which way do you the Crank Pulley Bolt to loosen it?
Most Mazdas are counterclockwise to loosen it... Lefty loosey, righty tighty.. Careful, some years have locktite on them..
How do you loosen the hub nut on 95 Grand Cherokee which way left or right?
Counter clockwise to loosen.
As far as loosening the tension pulley to replace serpentine belt on a 1999 6cyl Alero is the bolt supposed to loosen?
no the bolt on the pulley does not need to be loosen just put ur wrench or rachet on the bolt head and turn either way till the pulley moves
