make sure that you are turning the right way to loosen nut. a lot of vehicles have left hand thread on wheel bearing nuts on one side of vehicle,and right hand thread on other side
Get a heavy mall (Sledge Hammer with a long handle) and hit the rubber part of the tire with considerable force. The vibration should loosen the wheel off the drum. Be careful swinging the mall If you are trying to remove the wheel bearing/hub assembly, you have to loosen the three bolts from the back of the knuckle and hammer on them to loosen the hub assmebly.
You play a G below the staff on the trumpet with the fingering 1 and 3, loosen the jaw if you are having trouble reaching it.
If you're having trouble turning left or right..I would suggest you loosen your trucks on the board and then get a feel to how loose or tight you want the board.
In most cases, no, however if you are having issues getting the piston into the caliper, it may be seized, or it may be a turn in caliper.
Remove the wheel from your 1993 Mercury Cougar. Loosen and remove the wheel bearing nuts. Remove the wheel seal and the wheel bearing. Reverse the process to install your new wheel bearing.
no loosen your arm shots dont hurt
To replace wheel bearing on a Peugeot 806, loosen lug nuts and jack the vehicle. Remove lug nuts, the wheel, brake caliper, dust cover, cotter pin, castle nut, and rotor. Unscrew hub nuts of the wheel bearing and replace with new.
It depends slightly on which of the components you are asking about, that is the pump, the rack and pinion or what ever. Please ask again being more specific about the exact bolts you are having trouble loosening or explain what you are trying to change or remove.
Having to much sex can loosen you up, or masturbating too much.
no! you need to push the pistons back into the calliper! you may need to turn them.
The front bearing for a Dodge Stratus is attached to the Hub. To replace it remove all the components on the hub assembly. There are three bolts that hold the assembly in place. Loosen the bolts and pry out the hub. Replace the unit.
no just the trans and transfercase and loosen the bolts on rear main bearing cap