Have your Trans Fluid cleaned and changed. Most businesses that do oil changes offer this service usually around 100 dollars
Sounds like your transmission dopped into limp mode (only gear 1 and two), that means you have only gear 1 and 2. this can happen, because of wrong signals coming from a faulty speed sensor (on the gearbox) or usually the solenoid or the filters in it are blocked. Replace the solenoid and your tranny will work again like new.
Take care if you let your Transmission Fluid be changed by incompetent cheap garages (e.g. the official Chrysler ones)... replace the oil by the same type as the old one was.
A change in price level would cause movement along the demand curve, but would not cause the curve itself to shift.
would the tierod cause the wheel to turn out
what would transmission not to shift in to overdrive
Adding or subtracting just one nucleotide would cause a frame shift mutation.
Out of transmission fluid, broken/disconnected shift linkage, failed pump, bad valve body seals, faulty torque converter... Any of the above or possibly even other problems could cause what you describe.
The gears in your transmission may be sticking or worn out. This would cause your transmission to not be able to shift.
The battery on your clicker is out of batteries
Leaky transmission lines would cause the fluid level to drop and eventually cause the transmission not to shift and go.
Cable too slack.
It would not work with out major modifications to every system of the car.
The transmission needs repair. The electronic control system causes the transmission to stay in 2nd gear when it detects a problem, such as slipping in 3rd gear or overdrive. This allows the car to be driven in an emergency.
I would suggest you go to a local salvage yard in your area. That would be the cheapest route you could go.