0
What would cause a clunking noise when turning right or left on a 1992 Buick LeSabre?
Wiki User
∙ 12y ago
Most likely,your CV axle(s) are bad. You will need to replace the axle(s).This happens as the vehicle gets more miles on it.
Wiki User
∙ 12y ago
Add your answer:
Earn +20 pts
2002 Buick lesabre crank dont start?
what can cause a 2002 buick lesabre to not crank
FAQ10what would cause a 1994 Buick LeSabre v6 to shut off my self going down the road?
what would cause a 1994 Buick LeSabre v6 to turn off going down the road.
What could cause the back floorboard of a 1993 buick lesabre to get wet?
Water.
What would cause a knocking or clunking noise from rear tires when turning?
You probably need your bearings repacked
What would cause a Clunking noise and vibration noise when turning and going over bumps?
loose or bad u joints.
Besides a coolant leak what else can cause a 1997 Buick LeSabre to overheat?
fan or thermostat not working
What is the cause of a loud whining noise when a 2000 Buick LeSabre speeds up but stops when it slows down?
Bad wheel bearing.
What could cause a 1994 Buick LeSabre to stall when attempting to accelerate over 50mph?
the tps is bad-throttle positioning sensor
What might cause a squealing engine noise on a 1997 Buick Lesabre?
Check the belts. The most common cause of squealing is a worn or loose belt on the front of the engine.
What can cause 1993 Buick LeSabre steering column smoke?
only thing that will cause smoke in steering column,is an electrical short in the wiring inside the steering column
What would cause a loud clunking noise when turning car steering wheel For example when you make a U-Turn or back out of drive-way?
Could be many things, ball joints usually make clunking noises (usually one when turning and one when turning the wheel from turning), cv joints usually make a clicking noise and vibrate under load. Have it checked out, les schwab will do it for free (check it).
What cause humming in right front wheel of 1994 Buick LeSabre?
wheel bearings are going bad, need to change your hub assembly
