answersLogoWhite

0


Best Answer

most likely the switch is bad, or the wire plug has a bad connection

User Avatar

Wiki User

15y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: What would cause the windshield wipers to work only on high speed on a Windstar?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

What would cause the windshield wipers to work only on high speed on a Chevy venture?

Bad switch? stalk bad wiper motor? bad low speed winding


Why would windshield wipers get stuck in the middle on lowest speed and not come down on a 2000 Amigo?

I have found that if you put rainex on the windshield everytime you change your oil you will not have that problem.


What would cause the windshield wipers to freeze in position when the switch is flipped to the high speed and how can they be repaired?

I have a 94 caprice that does this. Apparently it is either that speed only on the wiper motor that has a problem or the relay for the high speed may have failed and the motor may be ok. As it is a noncritical issue I haven't worried too much about it. If I find out more I will update this.


My 2001 Chrysler tc van started to have problems with the windshield wipers and turn signals yesterday. They just started to go wacky. Can anyone help me?

Usually a malfunction switch. The switch works on resistance that is read by the BCM then it turns on the wipers and selects the speed.


How do you fix the intermittent windshield wipers on your 1997 Lincoln Town car they stopped being intermittent and now only go at one speed medium fast?

Either a few wires are now unconnected or you just need a new Windshield wiper motor.


How are two speed wiper motor run in low or high speed?

windshield wipers have different kinds of speeds such as the ones listed below:Low speed: Low, Intermediate,HighNormal speed: Low, Intermediate,High (recommended speeds for rain and clean up)High "" hope i helped


What does the turn signal switch control on an 2002 explorer sport?

The multi-function switch inside the steering column has the turn signal lever and hazard lights button extending outside of the steering column it operates - turn signals - flash to pass - high beam headlights - windshield wipers ( on/off ) and intermittent speed settings for the wipers - windshield washer fluid squirter button


Abs light is On speed odometer is at 0 mileage is at --------- no cruise control is this the vehicle speed sensor on a Ford Windstar 2000?

Your Windstar is subject to a Ford recall for the cause of this problem.The cause is a leaking brake pressure sensor screwed into the bottom of the master cylinder.I would suggest contacting your Ford dealer confirm your van is covered (I believe every single Windstar is part of the recall), and arrange for the quick and easy repair.See "Related Questions" below for more


Where is the speed control device located on a 1995 ford windstar?

The speed control device or speed sensor on a 1995 Ford Windstar is located on the transmission. It is a plug in just behind the bell housing.


What kind of transmission malfunction will cause the overdrive light to blink on a 98 ford windstar?

speed sensor on top of transmission,if the speed sensor does not work then the shift inside the trans is broken and trans will need to be rebuilt


How do wipers achieve 2 speed operation?

by introducing resistors in the circuit


Why mostly in rainy days the windshield wipers on your 1998 Ford Ranger work only at highest speed with the switch turned all the way to the bottom?

Could be a bad wiper motor - has 2 windings one may be bad Could be a bad switch