Want this question answered?
Should be 2 mounting bolts at the rear of caliper
Two mounting bolts at rear of caliper - then slide caliper off rotor
Caliper retaining bolts. Torx T-40 or T-45
On the inboard side of the caliper.
.The 2000 Chevrolet Monte Carlo brake caliper bolt size is 9/16. The brake caliper bolt can be purchased at most auto-parts stores
Remove the wheel, locate the Caliper. On the inner side there are 2 bolts going through the caliper, remove those (before removing use a flat head screwdriver to compress the caliper some) remove caliper. If you are removing the rotors remove the 2 large bolts on the caliper bracket.
75 ft lbs
where is the thermostat at on a 2000 mercury mystique
Caliper Bracket 80 foot-pound, 19 mm bolt Caliper 37 foot-pound, 14 mm
HELLO IF YOU HAVE TAKEN OFF THE TWO BOLTS AND STILL WONT COME OFF USE A SCREW DRIVER AND PRY THE CALIPER UP FROM BETWEEN THE ROTOR AND CALIPER ALSO YOU CAN PUSH THE CALIPER BACK TOWARDS THE INNER SPRING BETWEEN THE CALIPER AND ROTOR SITS THIS WILL PUSH THE CALIPER BACK AND GIVE YOU EXTRA CLEARANCE TO PULL UP THE CALIPER
18-25 ft lbs.
not sure from your question which caliper bolts you mean. the caliper to mounting braket bolt is 63 foot-pounds (these are the two bolts per caliper that you remove to change the pads. They are a pin and pass through a rubber boot). caliper mounting bracket to suspension is 137 foot-pounds (these are the two bolts per bracket that you also remove if you are changing the rotor disk). the factory uses red loctite on them and they are a bear to get out.