answersLogoWhite
BMW 3-Series
Timing Belts and Chains
Honda Accord EX
Honda Accord LX

When does the cam belt need to be changed on a 2000 BMW 323 e46?

192021

Top Answer
User Avatar
Wiki User
Answered
2007-06-02 19:52:38
2007-06-02 19:52:38

there is no timing belt, or a belt to turn your camshaft if that is what you are wondering, it is all done by a timing chain and there is no service that they need.

001
๐Ÿฆƒ
0
๐Ÿคจ
0
๐Ÿ˜ฎ
0
๐Ÿ˜‚
0

Related Questions


http://forum.e46fanatics.com/showthread.php?t=522832


It should be changed every 60,000 miles on all years 1988-94 with a timing belt. It is not an interference engine.


The factors of 323 are 1, 17, 19, 323 For them to be common, they need to be compared to another set of factors.


it is to the left of the engine beside your belt.


(this assumes it is a car similar to the 1988-1993 generation Mazda 323)First, you need to take off the belt to the power steering pump. To get it off, you need to open two screws that hold the pump in place, and then slacken the belt with the tensioner screw.When that belt is off, you do a similar thing with the alternator belt. Loosen the bolts that hold the alternator in place, and you can move it a bit so the belt slackens.Same thing in reverse to get it back on again. The belt should move a centimeter or so when properly tensioned. You can't go by the slack of the old belt, since worn belts are usually way too loose. If the belt slips (and starts "screeching"), it's too loose. You may need to tighten it a bit after it's been "worn in".see if your local library has a shop manual to use for free.. I'd get a manual if your going to keep the car d


The highest watt headlight bulb you can use in a 2000 Mazda 323 is 65 watts. Most vehicles use a 55 watt bulb.



To change the alternator belt on a Mazda 323, first remove the right hand air shield under the can. Then locate the pulley tensioner of the AC and loosen the bolts on the pulley. Finally, remove the alternator pivot bolt under the alternator to remove the old alternator belt and replace with a new one.


Where can I find the fuel pump relay on a 2000 mazda 323



i need carburetors Mazda 323 1.5L rebuilding Harold E. Lozano P. harenlo@cable.net.co


First, disconnect the battery and then, remove the alternator and power steering belt, then the timing belt cover, the timing belt and the two pulleys, unscrew the pump bolts and that's it


If the engine is a non-interference type then the answer is NO. See the list below:


The battery is in the trunk on the passenger side under a plastic tray.


16.15%= 0.1615 in decimal= 1615/10000 or 323/2000 in fraction


Slacken the nut at the top of the alternator (14mm I think) and the bolt at the bottom. Pull alternator out until you can only get 10mm of movement in the belt on the longest run. Tighten bolts. You will need the car up and take the shield underneath off to get access.


you need to be more specific


the cluth, need to adjusted or need new one.


The factors of 323 are: 1, 17, 19, 323


i have 2000 bmw 323i 4 dr sedan and need to change motor starter , can tell me where it is? and step by step with pictures if it possible how to remove and reinstalled it . thank you max


This is from the Owners Handbook of my Mazda 323, 1996 : Alternator Drive Belt. 1. Loosen the alternator mounting bolt and adjusting bar bolt. Replace Fanbelt. 2. Turn the adjusting bolt until the correct tension is obtained. The deflexion should be 10mm. 3. Tighten bolts and recheck the tension.


The factors of 323 are: 1, 17, 19, 323.


323 + (323 * 0.038) = 335.27400The answer is 335.274.


The Mazda 323 fuel filter is located in the fuel tank. The fuel tank will need to be drained in order to change the fuel filter.


All carburetors need to be free of buildup or debris so that they can omit exhaust. The exhaust system on a Mazda 323 can be serviced by a mechanic.



Copyright ยฉ 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.