Front should refer to the side closest to the headlight end of the vehicle.
Front should refer to the side closest to the headlight end of the vehicle.
Front should refer to the side closest to the headlight end of the vehicle.
From what i have heard there is a couple clips towards the front of the console. after they are removed you can slide the entire console back to release the hooks securing it to the ceiling.
it is about centered between the tailgate and overhead console back of the sunroof.
According to the owners manual there are 2 switches ( for left and right flip out windows ) in the front overhead console that have the word VENT on them
I believe the switches are in the OVERHEAD console
One screw at front, one at back, two inside middle compartment. Remove screws and slide forward.
It pretty much sits still as the Warm Front passes 'overhead'. It will get pushed back/up a bit.
Remove the cupholder trim pieceDisconnect the electrical connectors.Remove the nuts from the side of the front floor console behind the axxess doors.Remove the nuts from the rear of the front floor console. lower rear corner may have to move seat all the way foward.Lift straight up on the front floor console and pull back in order to remove the console from the vehicle.
pry up the cover from the outside of the handle and remove the 7 mm screws front and back
there is a screw at the very front towards the winshield take it out and the unit should come down. take out the front compartment shield it should be empty, then make sure your clips are in place and put screw back in this is made easier with having the shield off when tightened replace shield
It pretty much sits still as the Warm Front passes 'overhead'. It will get pushed back/up a bit.
There are screws going through the bottom into the floor, should be about 6 in the front, middle, and back of the inside of the console.
I figured it out. Upclip the two clips closest to the windshield and move console back toward the read of the cap. There are two L shaped hooks at the read the hook into the top of the cab.