There are several things that can cause your 1995 Chevy Cavalier transmission not to go into drive or reverse. The most common cause is a lack of transmission fluid. A broken shifting fork will also cause the problem.
drive shaft could be out of balance or tires could be out of round
it will drive but when in reverse it wont move
You have to unplug the electronic speedometer sensor located on the top rear of the transmission. It can be reached from above but its easiest to find with a lift. I have a 1990 cavalier and it has the same issue. I think its a problem with the sensor module that the speedo reader plugs into.
Sounds like a torque converter lock up solenoid.
It might be a problem with your transmission because not all mx6's stall when you put it in drive or reverse.
Yes, this is normal. It will not pop out in reverse, only drive.
Yes...it's probably normal for an 11 year old Kia that is broken
that sounds like your transsion you should have it looked at although you can drive it with out reverse for quite a while
front wheel drive
Why would it stall or almost stall in Reverse but not in Drive? How long since it's received a tune-up and thorough check-up? How is the compression?
no , it's front wheel drive
No sir, it is front wheel drive.
Yes , it's front wheel drive
if the generated emf in motor is greater than supply voltage means the drive will goes to reverse
As fast as you can drive it in reverse.
Front wheel drive.
my 2000 gose in reverse but not drive
Because reverse is a lower ratio gear than drive and puts less load on the engine.