answersLogoWhite

0


Best Answer

its junk

User Avatar

Wiki User

14y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: When your 1999 merury tracer trio is running when you push in clutch starter ingages let it out it disingages what is wrong?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

How does a motorcycle starter motor work?

When you hit the starter button the starter relay send power to the starter. the starter solenoid pushes the starter shaft outward and the starter turns. When the solenoid moves the shaft it is connected to the jackshaft which ingages the starter gear on the clutch


Is it normal for the starter clutch casing to get hot?

if you have been running it for 3-6 hours then yes


What is the purpose of the overrunning clutch in a starter?

With the flywheel spinning at about 1,000 RPM at idle, the starter, if engaged with the flywheel, would be forced to spin between 15,000 and 20,000 RPM. Once the engine has turned over and is running, the overrun clutch will release the starter from the flywheel and prevent the gears from re-meshing (as in an accidental turning of the ignition key) while the engine is running


Is there a clutch safety switch on a 1991 Honda civic HB?

yes there is. it is located under neath the drivers instrument panel, at the top of the clutch pedal assembly. It has a 2 pin connector, one wire running to a ground, and the other wire running to the starter relay. the clutch pedal must be depressed to start the vehicle and allow the ignition to engage the starter.


Does a 2005 Yamaha V Star Classic starter have a clutch built into it?

NO, the clutch for the starter is internal. The clutch is on the gear that engages the starter gear.You have to remove left side engine case and remove flywheel to access starter clutch assembly.


Why does the Starter engages when clutch pushed in with no key in or with the car running ford escort?

neutral safety switch is messed up


2001 gmc sonoma it will not start you can start it by poppin the clutch which would indicate to you that the starter is ok you have replaced the starter relay switch and the clutch switch any ideas?

How do you figure the starter is okay just by popping the clutch? Popping the clutch uses the driveline to turn the motor over. The starter is not involved at all.


You have changed the clutch on your 95 escort and you still have to pop the clutch to start it?

The problem may be with your starter and not with the clutch.


How do you tell if the clutch switch is bad or starter on 87 celica gts?

Check for power at the clutch switch, then check for continuity through the switch with the clutch pedal depressed. If there is power and continuity, then the starter (or even ignition solenoid/starter relay) is the problem.


Where is starter on 95 rx7?

the starter on a 95 RX7 is on the flywheel which is just in front of the clutch, you will need to remove the bell housing around the clutch assembly to get at it however.


How do you start a car on GTR 2?

I know about the starter and ignition, but I click the ignition and then it clicks, then when I press and hold the starter it starts then immediatly stalls, I have tried it in neutral, in gear, with clutch, without clutch, with clutch and throttle.


Yamaha raptor 660 starter turns but dont start?

your one way starter clutch is blown out. same problem happened to me and raptors are highly know to break starter clutches. just buy an extreme raptor starter clutch kit.