where is the fuel pump cutoff relay located in a honda 88 prelude?
main relay
under the battery
The main relay is what sends power to the fuel pump and ignition.
it's on the left side under the alternator...
Check your owners manual, it will tell you in that.
The fuel pump relay for a 1997 Honda Prelude is located in the under-dash fuse/relay box, which is found on the driver's side of the vehicle, near the left kick panel. To access it, you may need to remove the cover of the fuse box. The relay is typically labeled, making it easier to identify among the other relays and fuses.
In a 1997 Honda Prelude, the starter relay is located in the under-hood fuse box. To access it, open the fuse box cover, and you will find the relay marked within the diagram on the cover. It's typically a small rectangular component that can be removed and replaced if needed. Always consult your vehicle's manual for specific instructions and diagrams.
I am sorry to say that there is not a cutoff of any kind.
The fuel pump relay on a 1998 Honda Prelude is located in the under-hood fuse and relay box, which is situated near the driver's side of the engine compartment. To access it, open the fuse box cover and look for the relay labeled for the fuel pump. If you're having trouble locating it, refer to the diagram on the inside of the fuse box cover for specific positioning.
The main relay switch on a 2001 Honda Prelude is typically located under the dashboard, near the driver's side. It can be found in the fuse box area, specifically on the left side of the steering column. To access it, you may need to remove some panels or covers. This relay is crucial for the fuel pump and ignition system operation.
To replace the reverse relay on a 2000 Honda Odyssey, first, locate the fuse box under the dashboard on the driver's side. Remove the cover and find the reverse relay, which is usually labeled in the diagram on the inside of the cover. Carefully pull out the old relay and insert the new relay in its place. Finally, replace the fuse box cover and test the reverse lights to ensure the new relay is functioning properly.