0
Want this question answered?
Be notified when an answer is posted
Add your answer:
Earn +20 pts
Where is the top timing mark on a clio 1.2?
sometimes don't have one. bottom pulley 6 o'clock, should be a mark on bottom of oil pump, or a locking pin in the flywheel sets it. cam mark should be about 12 o'clock. new belt has two white lines. timing marks, set the bottom first.
What is the correct timing marks for a 1993 Plymouth sundance?
tdc 12 degrees
How much does it cost to get the rear wheel bearing replaced on a Renault clio?
its no dear did ma front 1 it cost me 12+ vat try eBay there not hard to do
Where are the timing belt marks on a 1987 Nissan Stanza timing belt marks?
at top dead center, camshaft mark at 12 o'clock and crank at 5 o'clock. belt should also have marks if it a Nissan belt.
Where are the Cam belt timing marks vw golf 1.4?
Hi the timing marks are 1 on the bottom plastic cover at approx 12 clock the other on cam pulley behind line it up with the tappet cover hope this helps cheers Peter
How do you set the timing belt on a 1990 Subaru Liberty?
There should be timing marks on the pulley & you simply align them. Crank at 12/cam at 6.
Where are the timing marks for a 1999 Mazda 626 4 cylinder dohc?
When you say 'Timing Marks', there are several places on this engine that has various marks in regards to the Harmonic Balance, Camshaft sprockets, crankshaft, and timing cover. If you are checking the timing, you will use the marks on the timing cover. If you are setting or replacing the timing belt, you will want to use the camshaft sprockets in relation to the crankshaft/harmonic Balance. On this year, the crankshaft key notch should be 12'oclock and the sprockets should have the timing marks 'E' for exhaust and 'I' for intake aligned facing with the 'E' at 3'oclock and the 'I' at 9'oclock. Hope this helps. AJ
How do the timing marks on the crank cam line up what is the position to ensure proper timing?
the cam should be at 6:00 and the crank at 12:00
Camshaft timing marks for a Ford Laser?
Timing marks for twin cam 1.6L B6 engine. When crank pulley is at TDC on the compression stroke, 'E' & 'I' on the camshaft pulleys should be at 12 o'clock. Too easy.
How do you set timing marks on new timing sprokets?
Read the instructions that come with the new timing chain and gears. Generally, you would install the gears so that when the engine is #1 TDC the timing mark on the big gear is straight down and the timing mark on the smaller gear is straight up. There is an exception in that some model years have both timing marks in the 12 o'clock position.
1993 lancer 4G91 engineDo timing marks go both at 12 or at 3 and 9 oclock?
4g91
Do the timing marks line up with each other or on the block on an Oldsmobile Eighty-Eight 3.8L?
You're talking about the the marks on the timing gears Right? Because the timing gears have little marks on them. The top gear should have the mark at the 6 o'clock point(down on the bottom), and the smaller lower gear at the 12 o'clock position(up to the top). And these two marks should be lined up with each other.
