Yes you can. I replace my factory speakers on my 1998 Ford Expedition with Pioneers.
I am in the process of replacing the factory speakers in my wife's 2002 Liberty. Unfortunately, the deck does not drive the speakers, there are small amps in each of the front door speakers. Therefore, you cannot replace them with aftermarket speakers unless you replace the deck as well. The other option is to replace them, add an amp and rewire the entire system. This is not what I bargained for when I started this project but in the end it will be a lot better system then the factory system.
6.5 in front and 4x6 in back
Which speakers are you trying to replace? Front or rear?
How do you replace the fuel pump Honda prelude 1992
What is the eaziest way to replace an altanator on a 1998 Prelude SH?
Walmart.com and others sell a speaker spacer that should work.
It is a relatively easy job to replace your speakers depending on where they are located.
To replace the back speakers in a 2006 Acura TL, remove the SRS housing on both sides and the back panel of the speakers. Remove all wiring attached to the speakers and replace.
3.5"-4" in the dash and 6"-6.5" in the front door. To remove factory door speakers, you will have to drill out the rivets. To replace door speakers, you will have to fabricate a spacer ring or find one to purchase (door is very shallow).
To replace the speakers in a Town and Country you will need to remove the old ones first. Consult your owners manual for how to take out your speakers.
Check out www.tacotunes.com they have step by step instructions on how to replace your speakers in your Toyota tacoma.
go into the trunk and disconnect the wires and then pull the speakers out from the trunk and replace.
Remove door panels.. Unscrew old speakers..Screw in new speakers..replace door panels...ready 2 GO..
The speakers were all recalled due to a vibration in them. Take it to the Jeep dealership and they will replace all the speakers in the car at no charge.
To replace the front speakers in a Toyota Sienna the door panels must first be removed. With the door panels removed the speakers will be easily accessible and the mounting screws can be loosen. Unplug the speakers and remove them. Install the new speakers.
You cant replace it, it's all in one piece.
I have a Mitsubishi Diamante 2001! and had to replace the factory Infinity speakers as soon as I bought it. I went with Alpine Speakers. I make hip hop music, so whenever I finish making a track I usually listen to it in my car...my beats always peak because I use hard kicks and snares and the Alpine Speakers definitely can handle the bass. I'd go with them! I have a Mitsubishi Diamante 2001! and had to replace the factory Infinity speakers as soon as I bought it. I went with Alpine Speakers. I make hip hop music, so whenever I finish making a track I usually listen to it in my car...my beats always peak because I use hard kicks and snares and the Alpine Speakers definitely can handle the bass. I'd go with them!
open your trunk and you will see the speakers take the screw out and pull your speakers out
The diagram on how to replace valve covers on a 1993 Honda Prelude can be found in the service manual. If you do not have a copy of the service manual, Honda can provide itÊupon inquiry.
The question doesn't specify which version Prelude you are asking for. There are five generations with different ways to install for each one.
They would sound fine. Its the speaker that's 2 Ohms not amp. Marine speakers work great on motorcycles. Hold up better
I have a 1997 base Prelude. When you change the oil and replace the filter it's 5.1 Qts.