0
Where can you look to find out if your 1997 Tahoe ever had remote control door locks?
Wiki User
∙ 13y ago
Supposedly your Chevrolet service Dept can tell you the answer if you supply them with vehicle ID number
Even if you do have them, they don't work anyways. Thought my problem was the battery in the remote, changed it and nothing. Can't figure that one out. Even the side console door lock won't lock or partially locks the front passenger door. We've given up on that one.
Wiki User
∙ 13y ago
Add your answer:
Earn +20 pts
What controls the shifting of a 1997 Chevy Tahoe?
The PCM. POWER TRAIN CONTROL MODULE does. ( computer )
Where is the door lock remote control receiver for a 1997 Chevy Astro Van?
The door lock remote control receiver for a 1997 Chevy Astro van is located inside the cabin. it is found on the right kick plate.
1997 Chevrolet Tahoe towing capacity?
What is the towing capacity of 1997 Tahoe?
Ticking noise when idling or driving. It's a 1997 Tahoe.?
It's a 1997 Tahoe
What are the release dates for High Incident - 1996 Remote Control 2-19?
High Incident - 1996 Remote Control 2-19 was released on: USA: 3 April 1997
Will 2007 Tahoe rims fit on a 1997 Tahoe?
== == == == the 2007 probably has a different offset than the 1997. == ==
When was Locks of Love started?
Locks of Love was started in 1997.
Will a 2007 Tahoe dash fit into a 1997 Tahoe?
No not even close.
Will a 1995 Tahoe windshield fit a 1997 Tahoe?
Yes they are the same.
Why do I keep blowing my 40amp ignition fuse on my 1997 Tahoe?
The control wire to the solenoid may be deteriorated and shorting out. Or, you may have a bad starter.
Will a 2004 Tahoe 4l60e transmission fit in 1999 Tahoe?
I own a 1997 Tahoe and I have a 2003 trans, no fit
How do you replace tailgate door handle on 1997 ford escort wagon?
Remove the tailgate trim panel. Disconnect the remote control rod from the remote control. Disconnect the negative battery terminal. Unbolt the latch and remove the remote control. Disconnect the lock knob rod from the remote control and remove the rod. Disconnect the lock cylinder rod from the lock cylinder. Unbolt the remote control and remove it from the liftgate. Remove 2 nuts that hold the outside handle and take it out of the liftgate. Installation is the reverse of the removal steps.
