# The EGR valve is bolted to the rear cylinder head,at the transaxle end # Remove the air intake duct from the throttle body and air filter housing # Detach the vacuum line from the EGR valve.Disconnect the EGR pipe nut # Remove the EGR valve mounting fasteners # Remove the EGR valve and gasket from the manifold.Discard the gasket
This is a somewhat involved, but not difficult procedure. First, disconnect the 5 mounting bolts; 3 in front, 2 in back using a 10mm socket. You will need an extension or long 10mm socket to remove these bolts. Remove the bolt along the vacuum hose and it's bracket. Then, under the throttle cables there is the EGR temp sensor. This is connected to another sensor and both plug into each other. There is one nut holding a bracket that supports this sesnsor. In order to access this nut, you need to loosen the air hose assembly using a Phillips screwdriver. Slide the air hose loose, you can then use a socket to loosen the nut. Once nut is loose, carefully wiggle EGR valve off it's mounting studs and remove the gaskets with it. You will need a wrench to unthread the EGR temp sensor from the valve. Once EGR is off, replace gaskets, rethread the EGR sensor into EGR valve and reinstall...In some cases, you may have to transfer the lower mounting studs from the old EGR and transfer it to the new one.
The EGR valve on a 1999 Maxima is bolted to the rear cylinder head,at the transaxle.
It can be a little expensive to replace the EGR valve on the 1987 Volvo 240 DL. The job takes about 1 to 3 hours and can cost as much as about 240 dollars.
That means you ignition is lock but its not a BIG problem. Just unlock it.
DID U Clear the code B 4 U rechecked ?? Did U clean Out the Passage ways where the EGR Valve goes .
Buy a kit at auto parts or Wal-Mart comes with instructions
A code 32 indicates a EGR system fault. The EGR valve takes some of the exhaust gases from the combustion cycle and returns them into the intake air system. This cuts down on the NOx emissions. A faulty EGR valve shouldn't keep a car from starting. The repair for a code 32 is to replace the EGR valve.
No
It all depends on the production date of your Maxima. Federal emission Maxima 06-2000- 06-2001 are EGR delete.
The EGR valve is bolted to the rear cylinder head at the transaxle end
how do you replace a bulb in a fog light on a 2000 maxima?
what year maxima? 1989-1994 on the bottom.. 1995-2000 in the middle..
see the egr valve location on the 1999 Nissan Maxima-it should be very similar.
Remove the wiring harness from your 2000 Dodge Stratus EGR valve. Remove the EGR valve retaining screws. Reverse the process to install the new EGR valve.
I's a problem with the EGR system and or the EGR solenoid.
The Internet.
replace the egr valve the one you have is not good
I have recently replace my starte for 2000 nissamn maxima gle and it cots around 500 usd with parts and labor.
on the motor