I think the plug is behind the passenger side tail light remove the plastic pin and pull back the mud guard. You may need to remove the tail light too depending on the kit you bought
The factory wiring harness for the trailers will plug in under the back of the vehicle in the area of the spare tire, the harness plugs into the wiring harness for the tail lights.
2006 Dodge Dakota - Where do i find the trailer wiring harness
Make sure that the wiring harness is properly grounded. Baring that, there is probably a short in the wiring somewhere. A short means the two wires used in trailer lighting are touching someplace.
U-Haul sells a kit with instructions
You can find a trailer wiring harness for a Chevrolet in a Haynes repair manual. The manuals are available at most auto parts stores.
find wiring harness in the back of the vehicle the same one that goes to the tail lights wire it through that wiring harness use test light to make sure you arein the right wiring harness
Auto parts stores can sell you a trailer harness that plugs in between your existing truck harness. The electrical connection used is usually located behind the rear bumper on the inside of the left frame. Directions will come with the trailer harness kit.
I'm not certain that the vehicle came factory-equipped with a trailer wiring harness. HOWEVER - if it does exist look CAREFULLY underneath the rear of the CR-V for the wiring to be tucked up and into the rear area somewhere, perhaps underneath the rear bumper housing.
Brake pedal switch, wiring, bulbs, bad trailer harness (if there), fuses...
very easy .I bought my wires on eBay ,,,the trailer harness plugs right into your lights no cutting at all
If there is a trailer wiring harness on the vehicle for towing unplug harness under drivers side rear tail light to eliminate the trailer wiring that's probably the issue then plug factory wires together
Trailer wiring harness part #118382 - any local Auto Parts Store should care this.