In the RADIATOR. Good luck doing that. It goes in the expansion tank. Open cap cool and add. Let warm up and check level.
In the reservoir.
See the answer for "How do you replace the drive belt in a 2000 Ford Focus?". The procedure is the same.
Antifreeze has to be put in at the overflow bottle.
According to the 2007 Ford Focus Owner Guide : The engines came from the factory with a 50 / 50 mix of distilled water and YELLOW colored antifreeze ( meeting Ford specification WSS-M97B51-A1 ) * I would say no because the green antifreeze specifications are different
sae approved 5w-30
Pry up on the tensioner pulley.
Were do i insert coolant in my c320 2001 mercedes
You Put The Antifreeze In The Coolant Resivore.. These Escape Don't Have A Radiater Cap..... Hope This Helps
Was built with Dexcool
To replace a lower radiator hose on a Ford Focus, use a bucket to catch any antifreeze that might leak. Loosen the clamp from both ends on the hose that needs to be replaced. Put the clamps on the new hose and reposition the hose on the radiator and the other end where it needs to go. Tighten the clamps. Refill the radiator with antifreeze.
You put it directly into the coolant over flow chamber.
Ford Focus sales provides the option to purchase a used Ford Focus. On the website, it asks consumers to put in their zipcode so that they will be able to find a Focus in their area.
the tailgate opens when i have braked in a ford focus automatic the tailgate opens when i have braked in a ford focus automatic
You DO NOT gap the plugs on the Focus, you will ruin the platinum coating and they will not fire correctly. Put them in STRAIGHT OUT OF THE BOX!!
In the engine coolant reservoir in your engine compartment on the passenger side ( usually a 50 / 50 mix of antifreeze and preferably distilled water ) Ford states to not exceed 60 % antifreeze
According to the 2000 Ford Windstar owners manual : It came from the factory with a 50 / 50 mix of distilled water and GREEN colored antifreeze ( meeting Ford specification ESE-M97B44-A ) * Ford states to not exceed 60% antifreeze in the mix *
Check with ford dealer or you can buy antifreeze that mixes w/ any types of antifreeze - but check first or you can cause problems
r134a for a 2001 Ford Expedition
You put it in the coolant reservoir, a plastic container with a radiator cap on it
A good quality antifreeze i.e. Prestone or Zerex mixed 50/50 with water
You should use a gallon of coolant.
50 / 50 mixture of antifreeze and preferably distilled water usually ( Ford says not to have less than 40 % antifreeze and not more than 60 % antifreeze )
According to the 1998 Ford F-150 owners manual : It came from the factory with a 50 / 50 mix of distilled water and GREEN colored antifreeze ( meeting Ford specification ESE-M97B44-A ) in the engine cooling system * Ford states not to exceed 60% antifreeze in the mix *
u put it in recovery tank if need it only!