0
The year of the vehicle usually helps, but in this case it might not. The engine sits sideways in the car so the front of the engine is facing the passenger side. The sensor should be at the front of the engine on the right side, (front bumper side), at the bottom of the engine, next to the lower drive belt pulley, (crankshaft pulley). Just above the oil pan at the middle of the engine towards the transmission. Unbolt it and inspect it for cracks.
Wiki User
∙ 15y ago
Add your answer:
Earn +20 pts
91 Dakota crank sensor location 3.9 v6?
No Crank Sensor until 1992
Where can you find the crank sensor on a 91 sunbird 3.1?
Where is crank sensor on 3.1 v6 91
What is the crank sensor location on a 1990 Dodge Dakota 3.9L V6?
Dodge Dakota V6's didn't have a crank sensor until 1992.
Where is the crank shaft position sensor on a 2001 Nissan Pathfinder v6?
Where is the crank shaft position sensor on a 2001 Nissan Pathfinder v6?
Where is the 97 Buick LeSabre 3.8 V6 Coolant temperature Sensor?
where is coolant sensor on a 97 buick lasbre
Where is the crank sensor located on a Lincoln ls v6 engine?
where is the crankshaft sensor location on a lincoln ls v6 2003
Crank sensor Santa Fe 2.7 v6?
abajo.
If the crank position sensor 1998 Dodge Dakota magnun v6 is not work what would happen?
If the crank sensor is not working, the engine will not run.
Need to know location of crank sensor for 2.8 v6 buick regal?
side of the block, against the firewall, passenger side side of the block, against the firewall, passenger side
On a 1996 Chrysler sebring 2.5 V6 what is at the receiving end of the crank position sensor does it get its signal from the crank shaft itself or is something attached to the crank?
There is a tone wheel on the crank/flywheel that the sensor reads off of, if that is your question.
Where is the Saturn 2000 l2 3.0 v6 crank position sensor located please help?
behind the crank pully
Where is the crankshaft sensor on 2000 Buick Regal 3800 V6 and how do you change it?
The sensor is located in between the crank pulley and front cover, just to the lft of the crankshaft. In order to change the sensor, you must, first, remove the crank pulley. With the damper off, unplug the sensor, and pull off the plastic cover. The sensor is mounted with 2 bolts, just to the left of the crankshaft. You'll need a deep 15mm socket.
