answersLogoWhite
Oil and Oil Filters
Ford Thunderbird
Ford Expedition XLT
Ford F-250

Where is oil sending unit on a 1985 Ford Thunderbird 3.8L V6?

323334

Top Answer
User Avatar
Wiki User
2006-11-12 00:47:01
2006-11-12 00:47:01

The oil sending unit is located directly under the oil filter...it has a electrical wire leading to it that you simply remove, then unscrew the sending unit...the reverse to install.

1

Related Questions

User Avatar

The 1988 Ford Thunderbird fuel sending unit wiring diagram can be obtained from most Ford dealerships. The wiring diagram can also be found at most auto-parts stores.

User Avatar

Where is the oil sending unit on a 2.8

User Avatar

Where is the oil pressure sending unit on 1992 ford ranger

User Avatar

Where is the oil sending unit on ford freestar

User Avatar

i just put a 4.6 in a 1994, the oil sending unit is located right on the oil filter bracket, ( where the oil filter screws on ) it has one wire that pushes onto it,

User Avatar

Do you mean the Temp sending unit, oil pressure sending unit, or fuel level sending unit?

User Avatar

wher is the oil sending unit for a 1999 ford f250 v10 triten located on moter

User Avatar

Any sensor that sends information to the computer or driver, such as fuel sending unit, oil pressure sending unit, etc.

User Avatar

The temperature sending unit on a Ford V10 gas 6.8 liter is on the front of the cylinder head. It is a true sending unit and not just an on and off switch.

User Avatar

Temperature Gauge Sending Unit The sending unit is located in the front section of the intake manifold in the vicinity of the thermostat.

User Avatar

Located, under hood, center, lower engine area, mounted on driver side front of engine block.

User Avatar

Its located behind the power steering pump, tucked in there nicely out of reach.

User Avatar

It could be your fuel gauge or your sending unit or the wires connecting them . If you have dual tanks it could be the switch that changes tanks. The most likely culprit is the sending unit in the tank.

User Avatar

The oil pressure sending unit on a 302 ford is located on the block of the engine. It screws into the block and the sending unit goes on the end. The oil pressure sending unit on a 302 Ford is slightly above and to the left of the oil filter. I find it is easier to replace with the oil filter out.

User Avatar

where is the temp. sending unit located on a 1999 ford ranger xlt 6cyl 3.0l .Gauge does not work.

User Avatar

The oil pressure sending unit is located on the oil filter housing. Look above the filter and you will see a single wire going to the unit. You will need a sending unit socket to remove it. The tool can be purchased at any auto parts store for a nominal fee.

User Avatar

The sending unit for the computer is on the drivers side right behind the distributor. The sending unit for the gauge in the cab is on the passenger side (both tap directly into the intake

User Avatar

The temperature sending unit on the 1999 Ford Taurus v6 is on the rear of the engine. It is closer to the driver side about 7 inches down.

User Avatar

the oil sending unit its right next to the dipstick and the oil filter on the ford 300 its a screw in device with a wire protruding from it.

User Avatar

The fuel sending unit for your fuel gauge is inside the fuel tank with the electric fuel pump

User Avatar

The temperature sending unit for this truck is located in the cylinder head on the right hand side at the very back (right behind the exhaust outlet for #6 cylinder)...... you out ...........

User Avatar

The oil sending unit on a 5.4 liter Ford is located along the side of the engine. It constantly monitors the flow rate and pressure of the oil.

User Avatar

Check with a manual gauge to confirm no oil pressure Could just be a bad oil sending unit Could be a bad oil pump Excessive engine wear

User Avatar

No, there is not. You will have to remove the gas tank. But before you do you need to check power and grounds to the sending unit.

User Avatar

Remove the fuel tank and then the sending unit. The fuel pump is on the fuel sending unit bracket.


Copyright © 2020 Multiply Media, LLC. All Rights Reserved. The material on this site can not be reproduced, distributed, transmitted, cached or otherwise used, except with prior written permission of Multiply.