It is located under the grill on the dash of the vehicle. It is held in place with Phillips head screws and you will need a very short screwdriver or a ratcheting bit.
It is located on the transfer case this is the motor that shifts your four wheel drive
In a 1988 Chevy pickup the ECM is located behind the glovebox.
Most likely it is the TFI module mounted on the back side of the distributor. Takes a special tool to remove it, available at auto zone for about 5 bucks.
It depends on what you mean by computer. The '88 bronco has an TFI control module mounted on the distributor. It is held on by 2 Phillips screws and should be relatively easy to take off without removing the distributor.
where is the ignition module located on a 1988 Mazda b2200
How do you change the ignition control module in a 1988 Chevy Silverado 5.7L
Under Dash Passenger side to the right of the kick panel
OP here- Got it looked at and the entire distributor went out. Problem solved.
Where is fuel filter on 1988 bronco II?" HOW TO CHANGE IT ---- It is located underneath the car, driver side area.
I am trying to find the 1988 chevy beretta computer module and where is it located?
The Electronic Control Module (ECM) is located under the right hand side of the instrument panel.
how do you remove the ignition control module on a 1988 ford f-250 pickup?