answersLogoWhite

0


Best Answer

Under the battery, on the battery tray.

User Avatar

Wiki User

12y ago
This answer is:
User Avatar

Add your answer:

Earn +20 pts
Q: Where is the Battery Temperature Sensor on a 1996 Jeep Cherokee?
Write your answer...
Submit
Still have questions?
magnify glass
imp
Related questions

Is the transmission pressure sensor and the transmission temperature sensor on a 1996 jeep grand Cherokee the same?

Two sensors in the same part, yes.


Where is mass air flow sensor in 1996 grand jeep Cherokee?

A 1996 Jeep does not have a mass airflow sensor.


O2 sensor relay location on 1996 Jeep Cherokee 4.0?

location of relay for heated o2 sensor 1999 jeep Cherokee sport


Where is the camshaft sensor on a 1996 4 liter grand Cherokee?

The cam sensor is inside the distributor under the rotor.


Where is the cam shaft position sensor located on a 1996 Cherokee sport 4.0?

The cam sensor is inside the distributor.


What is the Plug or sensor above oil filter on 96 Cherokee?

The plug or sensor above the oil filter on a 1996 Cherokee is the oil pressure sending unit. This sensor controls the oil pressure gauge.


Where is the oil sensor located on a 1996 jeep Cherokee?

The oil sensor is located above the oil filter next to the distributor.


Does a 1996 jeep grand Cherokee have a mass air flow sensor?

No, it uses a MAP sensor (manifold absolute pressure)


Will a 1996 Jeep Cherokee sport 4.0 go into a 1989 Jeep Cherokee sport with the 4.0?

It will bolt in, but the intake on the 1996 is different and the cylinder head on the 1996 does not have the temp sensor for the gauge in the same location.


Where is the cam sensor located in a 4.0 engine in a 1996 Jeep Cherokee Laredo?

It is in the distributor.


1996 where is the ECT sensor Camry 1996?

The ECT or the Engine Coolant Temperature Sensor is a switch. This switch is located on the bottom of the radiator in the 1996 Camry.


1996 Cherokee Sport 4.0L your heat gauge is not working there is lots of heat you replaced the coolant temperature sensor but still is bottomed out any ideas?

Check connector and wire for shorts/breaks.