Want this question answered?
The blower motor resister block is located in the center of the dash. Remove the complete glovebox and look to the left and you will see it...............
Blown fuse? Bad blower motor? Bad blower motor resistor? Bad blower motor switch?
Under the hood on the passengers side near the blower motor attached to the housing......... I'm pretty sure that's where the "Relay" is located not "Resistor". The resistor may be located under or behind the glovebox.
Its under the winshield wiper assembly
Probably the blower motor resistor, check blower motor at the same time
the impeller are the fan blades themselves.
Blown fuse? Bad switch?
You most likely blew a fuse and have a bad blower motor resistor assembly
I'm not exactly sure for a '94 but on a '93 there is no fuse. It is one of a group of fuzable links located behind the battery.
On some years, there are 2 separate fuses, one for the switch and another for the blower motor. First make sure fuses are good, if all is good, the blower motor is located under the hood, pass side at firewall. There should be a purple wire going to the motor, on the high blower motor setting there should be 12v at that wire. If 12v is available at the purple wire, make sure your ground is good (blower motor ground is at the motor case - black wire attached). If both are good, most likely cause would be the blower motor itself. If 12v was not present at the purple wire, likely causes are the blower motor relay (which is found just above the blower motor), mode switches ie. vent/blend/defrost etc. (if 12v is not present after the switch - poss colours brown or brown with a white stripe) or blower motor switch ie. high/med/low fault.
check your blower motor, located under the dash board. its on the passenger side. if the leak is on the drivers side, i have no clue. but my hubby's car is leaking water from the blower motor on the passenger side. found out at the car wash...
On the passenger side under the dash is the blower motor held in with 3 small screws. First unplug the wire harness to the blower and remove the 3 screws. Installation is in the reverse order