on the intake manifold
on the intake manifold
what two wires are the iat from the maf sensor on a Mitsubishi eclipse gs
left side of the intake manifold.
The IAT sensor, on your 2003 Mitsubishi outlander, is located behind the dashboard. The sensor is on the drivers side of the vehicle.
It is the Intake Air Temperature sensor usually located on the air inlet housing. When malfunctioning it will post error code P0111 and illuminate the Service Engine Soon warning llamp.
The 2000 Mitsubishi IAT sensor can be found on the right side of the engine. The sensor will be just below the head deck.
Answerthe iat sensor is located in the mas air flow sensor housing its the transistor thing hanging down. looking at the plug its terminal 5 and 6Find from which side the terminals are!!
A 95 did not have IAT sensor
You can find the 1995 Pontiac Firebird 3.4 liter engine IAT sensor on the back of your engine. The IAT sensor will be a few inches above the transmission.
The 1995 Nissan Pathfinder IAT sensor can be found in the air intake hose. The IAT sensor will be between the air filter box and the top of the engine.
It's located in the MAF Sensor Box (Mass Air Flow). Grab a Haynes manual and find where all your air flows through.
It is integrated with the MAF sensor.
Check the air filter box.
Iat / Idle air temperature sensor was not used on that year.
part of the Maf sensor.by airfilter
The 1995 model did not use a Idle air tempture sensor ( IAT ) Did not need one for that fuel system.
IAT= intake are temperature sensor ECT= engine coolant temp. sensor
That year did not have a INTAKE AIR TEMPTURE SENSOR.
it is located, or rather mounted on your air intake system. Whether the intake is an aftermarket part of oem the IAT sensor/connectors are usually on the manifold of the intake.
The IAT is integrated in the Mass Air Flow (MAF) meter. It's the coffee can in the front passenger side of the car. It's a brown connector and on a GS it should have 6 wires where as on a GST/GSX it has 7 wires.
non turbos have them in the air intake mainfold, turbo engines have them on the inside the box that conects the air intake pipe and the air intake filter just remove the filter from this box and also remove this box from the air itake pipe and you can see the iat sensor in there
It's on the intake manifold.
connected to the air cleaner housing
its the sensor in the tube going in to the throttle body from the air cleaner